Stone chips...that are rusty
Stone chips...that are rusty
Author
Discussion

Tiggsy

Original Poster:

10,261 posts

283 months

Wednesday 21st August 2013
quotequote all
Got a few chips in metalic black pain that have been left by the previous owner and so rusted over. In the fact, the edge of the paint appears a little raised as if the rust has gone from the chip and under the surrounding paint (we are talking farctions of mm's here)

So - using halfords stuff, what do i need to buy and then do!

HustleRussell

26,708 posts

191 months

Wednesday 21st August 2013
quotequote all
The only way to fix stone chips is to sand the paint back to bare metal in the area and key, de-grease, prime and re-spray the panel.

Touching in the chip will help inhibit further corrosion but once the paint is lifting anything short of removing all of the lifting paint and the corrosion and re-spraying the panel is just delaying the inevitable.

If you want to touch it in, clean the area, spray some acid etch primer into the aerosol cap and daub it into the chip with a fine brush until the coverage is even and then touch the chip in with top coat.

Tiggsy

Original Poster:

10,261 posts

283 months

Wednesday 21st August 2013
quotequote all
i cant sand back the chip area alone by hand and then touch up?

HustleRussell

26,708 posts

191 months

Wednesday 21st August 2013
quotequote all
Tiggsy said:
i cant sand back the chip area alone by hand and then touch up?
That would enlarge the repair area a lot. The paint and aerosols you'll get from Halfords aren't the same type that is on the panel already so what you'll be trying to achieve is an even finish where two different paints have been used (pretty tough!)

It's up to you I suppose, how good a job you want, how much value you place on the car etc etc and of course your skill and patience level, but in my opinion with the amount of time you'll spend trying and failing to do a job which will meet your expectations, you may as well get a body shop to re-spray the panel to an as new finish using OEM quality consumables and proper facilities.

Tiggsy

Original Poster:

10,261 posts

283 months

Wednesday 21st August 2013
quotequote all
HustleRussell said:
That would enlarge the repair area a lot. The paint and aerosols you'll get from Halfords aren't the same type that is on the panel already so what you'll be trying to achieve is an even finish where two different paints have been used (pretty tough!)

It's up to you I suppose, how good a job you want, how much value you place on the car etc etc and of course your skill and patience level, but in my opinion with the amount of time you'll spend trying and failing to do a job which will meet your expectations, you may as well get a body shop to re-spray the panel to an as new finish using OEM quality consumables and proper facilities.
ok...very ball park cost of a fiesta bonnet spray?

and...if I touchup only, do I cause problems down the line? or just put off the inevitable

Ferosferio

297 posts

181 months

Wednesday 21st August 2013
quotequote all
Depends where you are and who's doing it but I would budget a minimum of £200 for the bonnet respray. Quotes will vary wildly, of course.

Tiggsy

Original Poster:

10,261 posts

283 months

Wednesday 21st August 2013
quotequote all
ahhh...ok, i had thought 2/3 times that.

and so me doing a quick touch up now wont affect the work they have to do?