Sealing Cap

[Spanish S2]

I know there was a thread on this recently but I can't find it. Where can I get a sealing cap from for my expansion tank / swirl pot. Is it a standard size that I can obtain from a motor factors/ garage.

[Sandgrounder]

Got mine from Partco. They said it was off a Granada!!!!

[GadgeS3C]

Expect a LOT of questions as to whether it's the vented cap or not...

Should be easily available from local motorfactors - take the old one and hope they don't read PH or you could be there for a while

[RayTVR]

I bought a standard 15 PSI cap from a factor, but found that most modern ones don't have a rubber seal, and so won't seal properly. Following advice from here cut a ring from an old cycle inner tube and stick on - Job done.

[RayTVR]

I bought a standard 15 PSI cap from a factor, but found that most modern ones don't have a rubber seal, and so won't seal properly. Following advice from here cut a ring from an old cycle inner tube and stick on - Job done.

[techbotics]

I got a 0 psi and 15psi one in ss from eBay I like them.

Cheers Damian S3

[Rower]

RayTVR said:

I bought a standard 15 PSI cap from a factor, but found that most modern ones don't have a rubber seal, and so won't seal properly. Following advice from here cut a ring from an old cycle inner tube and stick on - Job done.

Yep- that's the way to do it !!

I have got a number of these already cut if anybody wants one email me via my profile and you can have one free and for gratis !