Discussion
Not a very exciting or informative post but just had to share - after 8 years I finally found time to chase down the leaks and following some heavy rain over the last few days she's dry as a bone inside.
After sealing up what I though were all the right things the final leak that I couldnt seem to find turned out to be the rivets holding the VIN plate on!
SO no more leaks at the front, and a new hood has solved the leaks at the back, I can now crack on with getting the new dash and carpets :-)
After sealing up what I though were all the right things the final leak that I couldnt seem to find turned out to be the rivets holding the VIN plate on!
SO no more leaks at the front, and a new hood has solved the leaks at the back, I can now crack on with getting the new dash and carpets :-)
After extensive use of sikaflex this is where the water was getting in on mine:
1 Clutch cover as shown by Daz above (even if it looks sealed if you haven't done it yourself it could be leaking)
2 Brake master cylinder reservoir
3 Brake reservoir electrical connector
Other contenders:
4 Rivets on VIN plate (easily visible if you lie on your back in the footwell)
5 Door seal (there should be a "cut out" section just at the front of the sill, if not water can trickle down the inside of the sill and soak the carpet)
6 Vacuum pipes from plenum to brake servo and throttle cable
7 Poorly fitting roof
Mine is now as tight as a nuclear sub!
1 Clutch cover as shown by Daz above (even if it looks sealed if you haven't done it yourself it could be leaking)
2 Brake master cylinder reservoir
3 Brake reservoir electrical connector
Other contenders:
4 Rivets on VIN plate (easily visible if you lie on your back in the footwell)
5 Door seal (there should be a "cut out" section just at the front of the sill, if not water can trickle down the inside of the sill and soak the carpet)
6 Vacuum pipes from plenum to brake servo and throttle cable
7 Poorly fitting roof
Mine is now as tight as a nuclear sub!
It was leaking through every possible place. Worst was the brake reservoir with the clutch reservoir a close second. Next time I get under the bonnet I'll grab a pic and post it up with all the areas highlighted.
Its not pretty as I was so fed up I used a significant quantity of sikaflex but it stopped the leaks.
The other place I was getting leakage was around the screen wash pipes. The rubber grommets were knackered and water was running in through the gap.
Its not pretty as I was so fed up I used a significant quantity of sikaflex but it stopped the leaks.
The other place I was getting leakage was around the screen wash pipes. The rubber grommets were knackered and water was running in through the gap.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



