Flexi exhaust join size...

[Chuffmeister]

Just a quick question, but the single pipe that comes from the y-piece; is it a 3" external diameter or internal diameter? My Chim has got a flexi pipe that goes from the end of the Y-piece to the main exhaust, and it has snapped away (couldn't get it out this eve as I needed to remove the y-pice as well and didn't have time). I was going to replace it with the below, so just wanted to know if it will fit? If you know somewhere that does the same cheaper, that would be good to know too!!!

http://www.ebay.co.uk/itm/250-x-76mm-10-x-3-Flexib...

Cheers!

[SILICONEKID343HP]

That wont fit ,to bulky.

http://www.thetvrshop.com/TVR/Parts_details/TVR%20...

[Chuffmeister]

Cheers for that! Do you know if there's one that doesn't need to be welded or only welded at one end? My flexi connects directly to the Y-piece, so cannot be welded at this end.

[NZ fan]

I think you will find that the flexible section that is in your car is a different design to that one. It looks like it would be too bulky around the woven section to fit in the limited space available (with adequate clearance). I think the original is more like I have seen on commercial vehicles?

[Chuffmeister]

Cheers, Perhaps I should get a standard one and get two clamp ends welded on. I'll get back under the car and measure it.