456 Suspension advice
Discussion
My 456 is currently stuck in track ride mode which is great fun but I want it to work properly in all three settings. Is there anyone willing to speak with my mechanic who is flummoxed but not clueless.
I live in Pembrokeshire - miles from decent Ferrari garages, but close to lovely roads...
I live in Pembrokeshire - miles from decent Ferrari garages, but close to lovely roads...
Section F page 41 is on the self levelling suspension.
http://www.ferraridatabase.com/The_Downloads/The%2...
only the rear are hydropneumatic self leveling, and I don't think that's the OP issue.
They are very similar to the BMW 7 series of the same age.
Assuming its a GT rather than a M GT, he has 3 settings - hard, medium and soft.
Each shock absorber has a motor on top of it - as on the 355 and 550 also - these are tested on power up.
They are very similar to the system used on the Corvette.
Its unlikely all 4 have failed - you should be able to see the tops move I have been told.
Their is an ECU that takes the speed reading, vertical acceleration, steering angle and brake pressure to determine the changing of the setting
This is explained in the WSM section F29 - you can download that from the site of the previous poster - let me know if your struggling and I'll send a copy.
My suspicion would be sensor failure somewhere, or at worst ECU failure.
A warning light should light on the dashboard - and the SD1 unit can determine the exact fault according to the WSM.
Hope this helps.
They are very similar to the BMW 7 series of the same age.
Assuming its a GT rather than a M GT, he has 3 settings - hard, medium and soft.
Each shock absorber has a motor on top of it - as on the 355 and 550 also - these are tested on power up.
They are very similar to the system used on the Corvette.
Its unlikely all 4 have failed - you should be able to see the tops move I have been told.
Their is an ECU that takes the speed reading, vertical acceleration, steering angle and brake pressure to determine the changing of the setting
This is explained in the WSM section F29 - you can download that from the site of the previous poster - let me know if your struggling and I'll send a copy.
My suspicion would be sensor failure somewhere, or at worst ECU failure.
A warning light should light on the dashboard - and the SD1 unit can determine the exact fault according to the WSM.
Hope this helps.
I agree with Davo. If you have a suspension warning on then there is an issue somewhere that needs diagnosing. If you don't have the warning on, but the rear suspension of the car has suddenly got extremely hard, you may have an accumulator fault. They cross match to BMW units which are cheaper than the Ferrari ones, part number is 37211132043.
I had a couple of failing actuators over the last 4 years and that is the sign I got. You could try ordering an actuator and then ask your engineer to rotate on each shock absorber until the light goes away but I think you also have to reset the engine management on every trial. I think that you might be able to do that by disconnecting the battery for some time but would be better if someone else could confirm.
Gassing Station | Supercar General | Top of Page | What's New | My Stuff


