Help Please - Indicator problem - 996 Turbo
Help Please - Indicator problem - 996 Turbo
Author
Discussion

stubbsy996

Original Poster:

785 posts

242 months

Saturday 12th October 2013
quotequote all
When indicating left repeater flashes much faster than it normally does! Near side indicator in lamp housing unit not working but side repeater is!
Offside works normally.
Changed the bulb and cleaned up the connection.
Also tried changing the fuse but everything else on that circuit fine.
Anyone else had and solved this problem?

Trev450

6,751 posts

201 months

Saturday 12th October 2013
quotequote all
I don't wish to state the obvious but have you checked if there is power getting to the lamp that's not working?

Pope

2,653 posts

276 months

Saturday 12th October 2013
quotequote all
Usually a lamp connector issue for that fault. Try removing the headlight and wiggling the connector that should be secured to the headlight carrier, if it's secure spray a small amount of WD40 (or similar) onto the seal around the connector and into the connector in the lamp itself. Make sure the lamp is fitted correctly on the rails when you push it back in.

StuB

6,695 posts

268 months

Sunday 13th October 2013
quotequote all
I found the the metal lugs the contacts on the bulb touch need gently teasing out when i had the issue. The whole lense comes out via the crank handle in the bonnet ( pull trim back) & then the indicator bulb socket comes out with 1/4 turn. You can then access the lugs with an electrical screwy.

Hth.

Stu

foreverme

569 posts

207 months

Sunday 13th October 2013
quotequote all
I had the same try removing and reseating the headlight then push in again/use the tool to lock

stubbsy996

Original Poster:

785 posts

242 months

Monday 14th October 2013
quotequote all
Thanks to everyone who offered advice.
Problem now solved smile
Removed the head lamp unit again, took the indicator bulb out and bent the metal connector out slightly with a small screwdiver. Replaced the head lamp unit but no go! Repeated the procedure this time bending the connector out a little more. Replaced the head lamp unit and this time it worked!!

StuB

6,695 posts

268 months

Monday 14th October 2013
quotequote all
stubbsy996 said:
Thanks to everyone who offered advice.
Problem now solved smile
Removed the head lamp unit again, took the indicator bulb out and bent the metal connector out slightly with a small screwdiver. Replaced the head lamp unit but no go! Repeated the procedure this time bending the connector out a little more. Replaced the head lamp unit and this time it worked!!
wink