Battery light on - big fuse?
Discussion
Mark. said:
It's a distinct possibility Phil, not been touched since I had it.
Mine was over at Lloyds and they started it and it did just what you described - they lobbed in a new fuse and lubed it up for me for free. 
Mark. said:
Might just stick it in the garage til the weather warms up a bit and use the other one. Who needs the roof coming off anyway.
It's one of two things:
100 amp fuse
Alternator
Not the 80 amp in the footwell - nothing much would work if that one had gone.
I have had the fuse go twice, the alternator once.
I don't remember the battery light coming on when the fuse went.
I do remember it coming on when the alternator failed on the back straight at Cadwell Park.
The 100 amp fuse is between the battery and the alternator. If it goes the alternator cannot charge the battery.
If the alternator goes, the alternator cannot charge the battery. Same result, different cause.
To test both, get a multimeter. £8 Maplins. Same product, £20 Halfrauds.
Ignition on, don't start the car. 20 volt scale on multimeter. Black lead onto the engine block. Red lead into hole on the top back of the alternator. 12.6 volts, fuse fine. 0 volts, fuse buggered.
If 12.6 volts, while holding multimeter leads in same places, get a passing yokel to start the car. Voltage should change to over 13 volts. If no change, take alternator to auto electrician to prove its faulty.
The fuse is strapped to the underside of the chassis, drivers side, close to where the rear arm of the lower front offside wishbone attaches to the chassis. It is in a black fuse holder case about 35 mm long, in the middle of a thick wire. Replace with a midi fuse off EBay.
100 amp fuse
Alternator
Not the 80 amp in the footwell - nothing much would work if that one had gone.
I have had the fuse go twice, the alternator once.
I don't remember the battery light coming on when the fuse went.
I do remember it coming on when the alternator failed on the back straight at Cadwell Park.
The 100 amp fuse is between the battery and the alternator. If it goes the alternator cannot charge the battery.
If the alternator goes, the alternator cannot charge the battery. Same result, different cause.
To test both, get a multimeter. £8 Maplins. Same product, £20 Halfrauds.
Ignition on, don't start the car. 20 volt scale on multimeter. Black lead onto the engine block. Red lead into hole on the top back of the alternator. 12.6 volts, fuse fine. 0 volts, fuse buggered.
If 12.6 volts, while holding multimeter leads in same places, get a passing yokel to start the car. Voltage should change to over 13 volts. If no change, take alternator to auto electrician to prove its faulty.
The fuse is strapped to the underside of the chassis, drivers side, close to where the rear arm of the lower front offside wishbone attaches to the chassis. It is in a black fuse holder case about 35 mm long, in the middle of a thick wire. Replace with a midi fuse off EBay.
Bassfiend229hp said:
JonathanT said:
QBee said:
I don't remember the battery light coming on when the fuse went.
I do remember it coming on when the alternator failed on the back straight at Cadwell Park.
The light came on on mine both times the fuse had broken.I do remember it coming on when the alternator failed on the back straight at Cadwell Park.


QBee said:
It's one of two things:
100 amp fuse
Alternator
Not the 80 amp in the footwell - nothing much would work if that one had gone.
I have had the fuse go twice, the alternator once.
I don't remember the battery light coming on when the fuse went.
I do remember it coming on when the alternator failed on the back straight at Cadwell Park.
The 100 amp fuse is between the battery and the alternator. If it goes the alternator cannot charge the battery.
If the alternator goes, the alternator cannot charge the battery. Same result, different cause.
To test both, get a multimeter. £8 Maplins. Same product, £20 Halfrauds.
Ignition on, don't start the car. 20 volt scale on multimeter. Black lead onto the engine block. Red lead into hole on the top back of the alternator. 12.6 volts, fuse fine. 0 volts, fuse buggered.
If 12.6 volts, while holding multimeter leads in same places, get a passing yokel to start the car. Voltage should change to over 13 volts. If no change, take alternator to auto electrician to prove its faulty.
The fuse is strapped to the underside of the chassis, drivers side, close to where the rear arm of the lower front offside wishbone attaches to the chassis. It is in a black fuse holder case about 35 mm long, in the middle of a thick wire. Replace with a midi fuse off EBay.
Thanks matey.100 amp fuse
Alternator
Not the 80 amp in the footwell - nothing much would work if that one had gone.
I have had the fuse go twice, the alternator once.
I don't remember the battery light coming on when the fuse went.
I do remember it coming on when the alternator failed on the back straight at Cadwell Park.
The 100 amp fuse is between the battery and the alternator. If it goes the alternator cannot charge the battery.
If the alternator goes, the alternator cannot charge the battery. Same result, different cause.
To test both, get a multimeter. £8 Maplins. Same product, £20 Halfrauds.
Ignition on, don't start the car. 20 volt scale on multimeter. Black lead onto the engine block. Red lead into hole on the top back of the alternator. 12.6 volts, fuse fine. 0 volts, fuse buggered.
If 12.6 volts, while holding multimeter leads in same places, get a passing yokel to start the car. Voltage should change to over 13 volts. If no change, take alternator to auto electrician to prove its faulty.
The fuse is strapped to the underside of the chassis, drivers side, close to where the rear arm of the lower front offside wishbone attaches to the chassis. It is in a black fuse holder case about 35 mm long, in the middle of a thick wire. Replace with a midi fuse off EBay.
Just an update though - this morning it's all fine, no light on at all. Now thinking dodgy connection somewhere?
Definitely worth further investigation.
I would check the connections on the terminals within the small plastic 100A fuse box and change the fuse anyway (may have a crack in the fuse?). Also check the connections on the back of the alternator, the battery terminal connections, the connections on the starter motor where the live feed meets and for any breaks/ corrosion along the live feed itself.
You don't want to get a battery drain whilst you're in the middle of nowhere!!!
I would check the connections on the terminals within the small plastic 100A fuse box and change the fuse anyway (may have a crack in the fuse?). Also check the connections on the back of the alternator, the battery terminal connections, the connections on the starter motor where the live feed meets and for any breaks/ corrosion along the live feed itself.
You don't want to get a battery drain whilst you're in the middle of nowhere!!!
Mark. said:
Thanks matey.
Just an update though - this morning it's all fine, no light on at all. Now thinking dodgy connection somewhere?
Everything you've described, light coming on, then off, not starting etc happened to me recently and it was the fuse which obviously still had a bit of contact depending on the heat. X-Works replaced it with one of the more substantial tagged 125amp fuses.Just an update though - this morning it's all fine, no light on at all. Now thinking dodgy connection somewhere?
V8 GRF said:
Everything you've described, light coming on, then off, not starting etc happened to me recently and it was the fuse which obviously still had a bit of contact depending on the heat. X-Works replaced it with one of the more substantial tagged 125amp fuses.
+ 1. And don't just look at the fuse, take it out. More than one person has undone the two nuts and found they have a two piece fuse. It might make good contact when cold but be rubbish when hot.In my limited experience, alternators tend to break down gradually. Again this may be temperature related.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


