Has noble parts stopped working?

[mgbond]

Was going to put the manifold torque info on forum onto noble parts

[V1DL3R]

Was discussed in here a little bit: http://www.pistonheads.com/gassing/topic.asp?h=0&a...

[mgbond]

Oh Crap, has all that info been lost then?

[Green3R]

I think most of it is probably here as well- this is a bit more 'live' so there's probably more here.

That said, if the pages were made available then any missing info could be copied across to here, or hosted at an alternative site.
Yes, I appreciate that maintaining the site was a chore, but the info itself was contributed by owners for owners.

(Trying to be nice here; I wouldn't have the time or patience to administer the site so I understand why it's gone!)

[mgbond]

It wasn't just about the parts. It had fixes, which is very helpful

[Adrian W]

Green3R said:

I think most of it is probably here as well- this is a bit more 'live' so there's probably more here.

You think so?

[Green3R]

It's not my intention to devalue Nobleparts. It closed becuase people didn't support it and even went as far as setting up a facebook page as an alternative to Pistonheads!

I've just found that all the info I've wanted is here, and I hope on occasions I've added to it.

[ca700470]

Does anyone know where I can get a copy of the diagnostic/ecu software now NobleParts is no more?

Thanks

Mark

[V1DL3R]

I'm going to drop Phil a PM, I have a ton of web space I can use. Just got to figure out a way of keeping content safe and balance the management of the resource. My initial napkin thoughts are that it could just be a Repro. There will be no front end sign up - only a few people will be able to create accounts for others. That way people can get sounded out through this forum or genuine meets?

It's not ideal but it may be a good stop gap until a more permanent solution can be found or things change.

Thoughts and comments?