Lubricating your shaft
Lubricating your shaft
Author
Discussion

jojackson4

Original Poster:

3,049 posts

167 months

Sunday 8th December 2013
quotequote all
Got the hub off mine at the moment. The grease / black treacle stinks vile - is this right? If not what do I need to use to replace it. Thanks Peter

jojackson4

Original Poster:

3,049 posts

167 months

Monday 9th December 2013
quotequote all
Sorry that's the rear 1/2 shaft also do the cv nead any maintanece ?

carsy

3,019 posts

195 months

Monday 9th December 2013
quotequote all
Its just normal cv joint grease. It is black, and is probably stincking due to being past its best. Not a lot you can do the the cv`s other than clean them and re pack with new grease. The grease has probably been in there since day 1, so prob not a bad idea to clean it all out, inspect the cv`s and re pack. To be honest if you havent got any strange cloncking sounds from the rear end they are probably ok.

jojackson4

Original Poster:

3,049 posts

167 months

Monday 9th December 2013
quotequote all
Thanks Ian

swallet

453 posts

173 months

Monday 9th December 2013
quotequote all
Peter,

I found this site really helpful when I did the CV joints on my old Chim. It is a pig of a job. It's for VW's but we appear to share the same CV joint.
http://volksweb.relitech.com/cvjoints.htm

Hardest bit was removing the circlip holding on the CV assembly - you really need a decent set of circlip pliers - watch out - mine pinged off across the garage and it took half an hour to find.