advice please audi s4 b6 chain replace or not
Discussion
Have rough running 2003 s4 4.2
codes being p0011 - camshaft position actuator bank 1 timing over advance
p0340 and p0345 - both sides camshaft position sensor fault
So is it just the camshaft actuator gone? (known to wear in this year due to soft metal creating oval holes - well thats what is says on the web. Or has a guide gone?
(engine still quiet with only rattle at startup but noisier than usual under load)
If just the camshaft actuator gone then can be done from above engine, so big cost difference.
help please
codes being p0011 - camshaft position actuator bank 1 timing over advance
p0340 and p0345 - both sides camshaft position sensor fault
So is it just the camshaft actuator gone? (known to wear in this year due to soft metal creating oval holes - well thats what is says on the web. Or has a guide gone?
(engine still quiet with only rattle at startup but noisier than usual under load)
If just the camshaft actuator gone then can be done from above engine, so big cost difference.
help please
Thanks for the quick response, Ahh maybe so. Oh well can anyone in the uk recommend an indie to call as the audi dealers near me were useless this after noon "the chain is for the life of the car, we have never done one, bring it in so we can throughly test other causes" - ie waste money in my opinion.
I've read it is around 15 hours (2 days) to get the engine out and back in.
Parts are around £800, it's possibly just one of the cam chain guides (plastic) which has broken, but would make sense to replace the tensioners themselves if they look like they are worn.
At my local indie, that would be £50 + VAT per hour, so around £900 labour + parts. A bill of around £1,600, or £2k should cover unexpected items.
I'd also change the clutch and flywheel whilst doing the job, would be very simple, and parts for that are around £800 too I believe (clutch £200 + DMF at £600)
I'd expect to the get the job done for around £3k all in, worst case scenario.
Buy a 2nd hand engine and you have the labour to still remove and refit, plus the danger of it happening again.
Edit - This might be a handy link for a decent/trusted garage to read before quoting you a price for the engine removal? http://www.euroaddiction.net/forum/b6-b7-s4-diy-ho...
Parts are around £800, it's possibly just one of the cam chain guides (plastic) which has broken, but would make sense to replace the tensioners themselves if they look like they are worn.
At my local indie, that would be £50 + VAT per hour, so around £900 labour + parts. A bill of around £1,600, or £2k should cover unexpected items.
I'd also change the clutch and flywheel whilst doing the job, would be very simple, and parts for that are around £800 too I believe (clutch £200 + DMF at £600)
I'd expect to the get the job done for around £3k all in, worst case scenario.
Buy a 2nd hand engine and you have the labour to still remove and refit, plus the danger of it happening again.
Edit - This might be a handy link for a decent/trusted garage to read before quoting you a price for the engine removal? http://www.euroaddiction.net/forum/b6-b7-s4-diy-ho...
Edited by matts4 on Thursday 2nd January 23:13
thanks all, think i am going to get it repaired. Would never buy another audi. Its not really this chain job. in last three months have had leak in drivers footwell, stupid alarm battery causing beeping in boot, rear wiper shorted out?, and dodgy starter/solenoid - which ill get changed when the engine out. Too many known faults in a so called high end product. Looking on the web the rear wiper and starter solenoid are just poor design, as is the ecu box (where my leak was). rant over. I have had many alfas and had little trouble. Again the chain job i half expected at some point as i bought it with 140K. Was eyeing up a s6 avant but not now
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


