Discussion
Mine (US version S2) had a retracting one in the right rear corner - where it gets bumped by the spoiler if on/up. However, the method of powering it is not the same as the modern/current ones. It had a up-down switch on the center dash which I took out when I rewired it. There is a thread on all that. Grady
Being that the cars made of plastic I hope all your antennas have the outer braid of the coaxial cable well grounded.
One route is to have plenty of 3M or similar metal foil sticky tape but whatever you do you should have a groundplane of sorts for the antenna to work properly and to keep any ignition interference in check.
Phil
420 SEAC
One route is to have plenty of 3M or similar metal foil sticky tape but whatever you do you should have a groundplane of sorts for the antenna to work properly and to keep any ignition interference in check.
Phil
420 SEAC
Transmitter Man said:
Being that the cars made of plastic I hope all your antennas have the outer braid of the coaxial cable well grounded.
One route is to have plenty of 3M or similar metal foil sticky tape but whatever you do you should have a groundplane of sorts for the antenna to work properly and to keep any ignition interference in check.
Phil
420 SEAC
Pahhhhh, what do YOU now??One route is to have plenty of 3M or similar metal foil sticky tape but whatever you do you should have a groundplane of sorts for the antenna to work properly and to keep any ignition interference in check.
Phil
420 SEAC

Stu
Gassing Station | Wedges | Top of Page | What's New | My Stuff



pops and bangs, thats music,

