Wishbones, anyone got a tape measure?

[gmw9666]

Afternoon all,

Need a little help, for my project I am currently sorting out the wishbones and uprights = http://www.pistonheads.com/gassing/topic.asp?h=0&a...

Would someone know or could share the T350 / Tam etc wishbone dimensions, overall width + length of the bush bit - in short A, B & C dims on front upper, rear upper and rear lower wishbones

Just want to cross check the dims with my chassis

Thanks in advance

Edited by gmw9666 on Monday 6th January 13:37

Edited by gmw9666 on Monday 6th January 13:37

[peteA]

Ok - you got me in the garage as my tamora is currently jacked up.

If I'm reading your request right, each bush holder is 35mm and from one end to the other is 490mm...taken lying on a cold floor with a tape measure so please allow for some tolerance!

[gmw9666]

Exactly what I wanted to hear

35mm fits and the 49cm is spot on also

I now need to buy some second hand wishbone and modify them with rosejoint ends

Cheers again

[gmw9666]

Lift off (thanks to my local Coventry based specialist )