Momo Trek R Fitting :)

[ShiDevil]

Hi chaps,

Fitted mine tonight but have a few questions.

1. TVR Badge and Horn. Use Momo Horn and badge on top? Replace Badge and use Momo Horn bit? What's your thoughts?
2. Use the housing that goes on the switch assembly or take off and just use the momo bit that fits to the switch assembly? Which the momo horn goes in, if that makes sense.

If anyone who has fitted this themselves can give a bit more insight that would be great

Or pm me number and I'll call you

Steve

[TVR nut]

Sorry not answering your question but did the wheel fit straight on or did you have to change the boss? If you did change the boss where did you get one?

Thanks

[ShiDevil]

TVR nut said:

Sorry not answering your question but did the wheel fit straight on or did you have to change the boss? If you did change the boss where did you get one?

Thanks

Mine was pre drilled already, however I had to drill out the mini boss that houses the dash buttons, not hard you get the boss from http://caraudiosecurity.com and specify in the notes area when you order what car you have, if you need one.

[alex_gray255]

Just stuck the badge on top. Easy and looked fine

[ShiDevil]

alex_gray255 said:

Just stuck the badge on top. Easy and looked fine

So the badge from the old horn on top of the momo horn badge?

[shep1001]

ShiDevil said:

So the badge from the old horn on top of the momo horn badge?

Yes, thats what I have done. Hairdryer to melt the glue then re-silicone in place.

Edited by shep1001 on Saturday 11th January 12:01