Audi a4 b7 2.0 tdi running on 3 cylinders
Audi a4 b7 2.0 tdi running on 3 cylinders
Author
Discussion

Duke of Boots

Original Poster:

1 posts

154 months

Saturday 11th January 2014
quotequote all
Hello all, my first post on this forum and in need of help.

The problems started when the cam belt idler pulley sheared its bolt and I had to whip the head off and have 8 valves replaced. I put the engine back together and all started well but had the engine management light on. Drove ok but after several days it suddenly felt as if it was only running on 3 cylinders, it will still rev right out but very lumpy at low revs. If I turn the ignition off this resets it for about 2 minutes and then it's like clockwork as if someone turns a cylinder off. Took it to an independent and got codes of camshaft sensor, No4 injector and maf. Have replaced injector, maf new injector loom. Yet to replace the sensor due to the amount of work invoked but could that cause this problem???? The sensor 3 pin connector from the ecu has a good earth, 12volts and a signal voltage of 4.5.

HELP!

Edited by Duke of Boots on Saturday 11th January 19:39