How do I remove spray paint from plastic wheel centre caps?

[h4mza]

Apologies if I posted in wrong section. So I used spray paint which wasn't meant for plastic. I first sanded the centre caps then sprayed one coat of primer then one coat of black but it didn't look good because the black kind of had faded with grey primer, so I sprayed another coat and same problem so then another coat. Later I realised I had used a wrong kind of spray paint So now the centre caps look messed up, some parts are dark grey and some are black with over spray and lot of bubbles.

Obviously I would like to get rid of the paint and do it properly, so does anyone know what's the best and easiest way to remove the paint without causing damage?

[Buff Mchugelarge]

Thinners or a very high pressure jetwash.

I suppose thinners applied through a very high pressure jet wash would be ideal.

[ChrisRS6]

New caps?

Thousands on the bay.

[zygalski]

Fine wet & dry paper.
Proper prep is the most important part. That & allowing plenty of time for what is a basic job.

[Easternlight]

Just sand it back to plastic and start again, with the right paint.

[Westy Pre-Lit]

I'd go with jet wash as well. If you not careful you can strip a whole wheel trim within seconds