Sealing ecu's ?
Discussion
They are sealed. They are in the engine bay, and not in the car unless 5.2. They don't normally suffer water ingress which is why I asked if it was the slow down ecu's that he wished to seal, as they are a common issue. There are two types, potted in either black or green resin. Early black units are more problematic but the greens also split and suffer. Over tightening the two seven mm screws that secure the units usually causes the splits to begin...
Thanks for so many replies guys !!
Its a 5.2 car and its the one thats by the rear right hand wheel that has got moist !!! because basically the driver side rear wheel kicks spray into the cat ecu, especially with the very poor weather recently !!!
I never drive the car in the rain / wet but had to last weekend hence the moisture.
As soon as it got damp it was out and on the aga for 24hrs, all dried out and it runs perfectly again, no slow down lights no nothing.
I have one black one and one green one and its the green that was giving the issue.
Both are ok but have shrinked away ( only by 1mm in one / two places ) from the case
Hope that makes sense
Going to increase the length of the bolts when i replace and add a damper
Thanks
Phib
Its a 5.2 car and its the one thats by the rear right hand wheel that has got moist !!! because basically the driver side rear wheel kicks spray into the cat ecu, especially with the very poor weather recently !!!
I never drive the car in the rain / wet but had to last weekend hence the moisture.
As soon as it got damp it was out and on the aga for 24hrs, all dried out and it runs perfectly again, no slow down lights no nothing.
I have one black one and one green one and its the green that was giving the issue.
Both are ok but have shrinked away ( only by 1mm in one / two places ) from the case
Hope that makes sense
Going to increase the length of the bolts when i replace and add a damper
Thanks
Phib
Yes that's the one that usually suffers because, as you say, it's right in the line of fire for all the water and crud thrown up from the right rear wheel. Just remove it and seal up the cracks. Put it back with a decent sized washer on the bolts to spread the load a bit and stop the cracks opening up again..
Gassing Station | Supercar General | Top of Page | What's New | My Stuff


