Procharger i-1 install article etc..
Discussion
I started to get interest in these late last year:
http://www.pistonheads.com/gassing/topic.asp?h=...

http://www.pistonheads.com/gassing/topic.asp?h=...

stevieturbo said:
They're available for the 2010 Camaro, so fairly sure that's same offset as VXR8, Vette etc etc ?
Still...unless there was a UK vendor offering the full warranty on it, not sure I'd risk buying one.
Well previous Gen they were different. I must admit I dont know about the gen4 stuff.Still...unless there was a UK vendor offering the full warranty on it, not sure I'd risk buying one.
Vette is same as vxr8 for sure, as I run a pulley from a vette.
Maybe the late model camaro also runs the vette offset, the previous didnt.
ringram said:
Well previous Gen they were different. I must admit I dont know about the gen4 stuff.
Vette is same as vxr8 for sure, as I run a pulley from a vette.
Maybe the late model camaro also runs the vette offset, the previous didnt.
From anything Ive seen the 2010 runs close to the engine same as Vette ( just look at LS3 etc water pumps )Vette is same as vxr8 for sure, as I run a pulley from a vette.
Maybe the late model camaro also runs the vette offset, the previous didnt.
I doubt Vortech will...as this thing will have a very small market. It's big, it's bulky, it's expensive....and does it really offer such a leap forward ? I just dont see it.
What I do see is lots of potential for expensive problems.
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff



would this kit fit a vxr8 without it needing to much modifying.
