Golf MK4 - Brake Woes
Discussion
I've just changed the rear pads and discs on my MK4 Golf and now I've got an issue I can't get my head around:
- With the engine off the brake pedal is rock solid
- With the engine running the pedal can be pushed right to the floor and no amount of pumping will bring it back up
- With the engine off again the pedal can be pumped up to solid again in 2 or 3 pumps
When I was doing the job I wound the caliper piston in using the correct tool and also didn't release any hydraulic lines (as not required) but I've bled the systems anyway just to make sure. My only suspicion is that I may have damaged a seal either on the caliper or the master cylinder winding the piston back, but this would surely cause a problem when the engine was off too?
Digging around on the internet hasn't been any help so I thought I'd open it up to the wise people of PH..!
- With the engine off the brake pedal is rock solid
- With the engine running the pedal can be pushed right to the floor and no amount of pumping will bring it back up
- With the engine off again the pedal can be pumped up to solid again in 2 or 3 pumps
When I was doing the job I wound the caliper piston in using the correct tool and also didn't release any hydraulic lines (as not required) but I've bled the systems anyway just to make sure. My only suspicion is that I may have damaged a seal either on the caliper or the master cylinder winding the piston back, but this would surely cause a problem when the engine was off too?
Digging around on the internet hasn't been any help so I thought I'd open it up to the wise people of PH..!
Not 100% sure, but could it have flipped the master cylinder seal? This apparently leads to a total loss of braking.
I thought when pushing the pistons back into the calipers, you were supposed to clamp the brake line and release the bleed nipple, so the pressure is released that way and not back into the system.
(I may be wrong on the above and am willing to be corrected!)
I thought when pushing the pistons back into the calipers, you were supposed to clamp the brake line and release the bleed nipple, so the pressure is released that way and not back into the system.
(I may be wrong on the above and am willing to be corrected!)
Thanks for the response
All I released was the reservoir when I wound the pistons back in so perhaps I've caused some problems there, but I still don't understand why that would change the pedal feel when its servo assisted (ie engine on) as any air locks/damaged seals would still have an effect when the engine was off...
All I released was the reservoir when I wound the pistons back in so perhaps I've caused some problems there, but I still don't understand why that would change the pedal feel when its servo assisted (ie engine on) as any air locks/damaged seals would still have an effect when the engine was off...
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


