Monaro rear anti roll bar
Discussion
I have just changed the rear anti roll bar drop link bushes without any problems!
However the two large bushes that attach the roll bar to the vehicle are a problem.
This is due to having hands like shovels and restricted access to the 13mm retaining bolt.
The fun started when I put the C- clamp over the new bush and tried to get the bolts to bite back into the captive nut. There was no way I could do it.
Is there an easy way to bolt this all back together?
Thanks again John
However the two large bushes that attach the roll bar to the vehicle are a problem.
This is due to having hands like shovels and restricted access to the 13mm retaining bolt.
The fun started when I put the C- clamp over the new bush and tried to get the bolts to bite back into the captive nut. There was no way I could do it.
Is there an easy way to bolt this all back together?
Thanks again John
Stick the rear of the car on axle stands
Undo the rear anti roll bar drop links
Undo the cables from the abs sensors which are mounted on the diff
Support the diff with a jack
Undo the 4 bolts where the rear of the diff mounts to the car. I think they are 10mm
Then double check that nothing will catch and slowly lower
Undo the rear anti roll bar drop links
Undo the cables from the abs sensors which are mounted on the diff
Support the diff with a jack
Undo the 4 bolts where the rear of the diff mounts to the car. I think they are 10mm
Then double check that nothing will catch and slowly lower
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff



