center console removal
Discussion
Just the leather gaitor bit? Think you can just pull that out without removing the console.
Anyway, my console was held in by two screws on each side at the front where your knee would be. Two screws underneath that pouch bit at the back that you can lift out and then the door knob is held on by a little grub screw at the bottom, which is a right pain to get at.
Anyway, my console was held in by two screws on each side at the front where your knee would be. Two screws underneath that pouch bit at the back that you can lift out and then the door knob is held on by a little grub screw at the bottom, which is a right pain to get at.
I have a tear that sounds very similar. I posted about it quite a while ago: http://www.pistonheads.com/gassing/topic.asp?h=0&a...
I've got the repair kit that someone recommended, but haven't got round to doing it yet.
I wonder if yours got torn in the same way: roof section falling down when raising/lowering roof?
I've got the repair kit that someone recommended, but haven't got round to doing it yet.
I wonder if yours got torn in the same way: roof section falling down when raising/lowering roof?
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




