Driveshaft - Alternative Part?

[MaccaTVR]

A driveshaft from most TVR specialists are around the £200+ mark!

Is there a ford alternative or something?

I know both CV joints that the driveshaft goes through are ford parts, so a ford driveshaft would be the same spline, its just a question whether the length is different?

Its for the rear of my Tuscan, however I'm sure they are all the same part from the chim onwards.

[wadsapple]

I have been chasing one for my challenge car for some months and it is defiantly not a ford shaft, they came directly from GKN I have been told. But I could really do with been proved wrong as GKN want over 600 quid to make me one

[gruffalo]

If it is the same as a Cerbera then it is off a Ford Granada.

[wadsapple]

This is mine and I,m told not off a Ford:

[spitfire4v8]

try these guys .. I think after brummmie was having driveshaft issues he uses shafts from dave mac and never had a problem. I think they have a lifetime guarantee or something very good anyway.
http://www.davemacprops.com/contact.html

[Brummmie]

Thats the guys, he says if i break it he will replace it FOC, cant say fairer than that?
I have a standard one if you want PM me if any use.

[MaccaTVR]

Thanks guys!

[NTEL]

Perry, did you try Northwest Prop shafts where I got my Tuscan Challenge ones from? The CV joints are ford Granada I've got a couple of spare ones.

[wadsapple]

hi Dave

turned out Dave mac were cheaper but I had mine cold straightened in the end. Think I will go Dave Mac if I have a problem at Snetterton with it, I do carry spare second hand ones but I don't know which was diff end on them so only any good as a last resort get me going option .