Front seat removal ?
Front seat removal ?
Author
Discussion

extra330

Original Poster:

177 posts

206 months

Saturday 29th March 2014
quotequote all
Anyone removed theirs ? vxr8
job for tomorrow, just looking for tips etc
cheers

Gary H 2008

3,507 posts

220 months

Saturday 29th March 2014
quotequote all
Very straightforward. Be careful with the plastic trim around the seat base - need to push forward and up (from memory) and don't forget about the plugs under the seats.

extra330

Original Poster:

177 posts

206 months

Saturday 29th March 2014
quotequote all
cheers Gary

Wyld Stallyn

2,056 posts

159 months

Saturday 29th March 2014
quotequote all
I seem to Recal Sommet about Airbag Lights Staying On (Now an MOT Fail!) after seat removal and bein a Right PITA to get turned back off again

But also if you Don't Swich the Ignition whilst you remove them and Before you put em back and plug em back in - IIRC you may get away with it..?

extra330

Original Poster:

177 posts

206 months

Saturday 29th March 2014
quotequote all
good point, ill bear that in mind tomorrow, i should be able to reset if it does throw a fault up, via torque

ARAF

20,759 posts

254 months

Saturday 29th March 2014
quotequote all
Wyld Stallyn said:
I seem to Recal Sommet about Airbag Lights Staying On (Now an MOT Fail!) after seat removal and bein a Right PITA to get turned back off again

But also if you Don't Swich the Ignition whilst you remove them and Before you put em back and plug em back in - IIRC you may get away with it..?
yes Leave the ignition off while the seat is unplugged, and you should be fine. smile

neiljohnson

11,298 posts

238 months

Saturday 29th March 2014
quotequote all
If you activate the light it can only be reset with a proper diag machine with the right Holden software on it
Took me a while to sort Vincem car as I had to get the provider of my machine to upload the software to my machine

Very few diagnostic machines have the right software for the ro's & r8's

VinceM

1,906 posts

169 months

Saturday 29th March 2014
quotequote all
neiljohnson said:
If you activate the light it can only be reset with a proper diag machine with the right Holden software on it
Took me a while to sort Vincem car as I had to get the provider of my machine to upload the software to my machine

Very few diagnostic machines have the right software for the ro's & r8's
Yes this is very true. Easy way is to leave ignition alone ie off until all wires reconnected!!