Air in take filter
Author
Discussion

wiganhsv

Original Poster:

148 posts

153 months

Monday 31st March 2014
quotequote all
hiya, im looking at getting an air in take fitted when i get my new exhaust system fitted. However im just after some opinions as to which are better. Over the radiator or, the other the air filter one? Do either have any cons benefits over the other?

Cheers

wozzza

404 posts

162 months

Monday 31st March 2014
quotequote all
OTR's tend to perform the best.

However, they also tend to cost more. So that's the con.

Drop in filters, won't do very much. On most of my cars that I fitted them in, it was a slightly better throttle response and that's about it. They are cheap though around £45-60. You wouldn't really be able to tell much difference.

Induction kits with open cone filters. They can go both ways, depends on the kit and how it is designed. Some you will actually lose power with, some will gain power.

If you want an intake I would be going for an OTR personally. Few companies that make them so plenty of choice.

wiganhsv

Original Poster:

148 posts

153 months

Monday 31st March 2014
quotequote all
cool, to go, OTR are there plenty for sale here in the UK for a VXR8 or is it an import job from Oz?

jameshsv

5,844 posts

191 months

Monday 31st March 2014
quotequote all
wiganhsv said:
cool, to go, OTR are there plenty for sale here in the UK for a VXR8 or is it an import job from Oz?
MF sell them.

jameshsv

5,844 posts

191 months

Monday 31st March 2014
quotequote all
wiganhsv said:
cool, to go, OTR are there plenty for sale here in the UK for a VXR8 or is it an import job from Oz?
MF sell them.

wiganhsv

Original Poster:

148 posts

153 months

Monday 31st March 2014
quotequote all
quality thanks for the help

jameshsv

5,844 posts

191 months

Monday 31st March 2014
quotequote all
wiganhsv said:
quality thanks for the help
Or goldy has just posted on facebook his ols air intake is going for £150 not otr though but reasonable quality.

wiganhsv

Original Poster:

148 posts

153 months

Monday 31st March 2014
quotequote all
just looked at the one on monkfish for £450, and seen one on Australian ebay for $210 (thats £116) would there be a massive difference between those 2?

FishmanUK

142 posts

195 months

Monday 31st March 2014
quotequote all
I fitted my VCM intake from monkfish a week or so ago on my LS3 VXR8

I logged the MAF before and after installation under similar conditions (dry and fairly warm, ~100 °C oil temp and same gear).

Stock peaked at 346 g/s and with VCM intake 381 g/s peak so quite an improvment in airflow.

monkfish1

12,522 posts

255 months

Monday 31st March 2014
quotequote all
wiganhsv said:
just looked at the one on monkfish for £450, and seen one on Australian ebay for $210 (thats £116) would there be a massive difference between those 2?
£425 to be precise smile There are no VCM intakes anywhere for $210. I can only assume that it is a different manufacturer you are referring to?

snowwolf

11,503 posts

206 months

Monday 31st March 2014
quotequote all
I have the Roto fab on mine, easy to fit but you will have to reshape the plastic rad cover so you have a nice seal when bonnet is shut so all the cold air is sucked from down below from lower intake grill, when you look at your lower grill, on the right hand side you will see an air scoop, that's where it sucks the air from (don't drive through flooded roads) it comes with everything you need to do a very good install, when madmaxhsv Had the car connected to his laptop out on a run he was impressed at the low intake temps.



Edited by snowwolf on Monday 31st March 20:33


Edited by snowwolf on Monday 31st March 20:36

ringram

14,702 posts

279 months

Monday 31st March 2014
quotequote all
wozzza said:
OTR's tend to perform the best.
Only on lightly modified or stock vehicles..

Z0m81e

249 posts

173 months

Tuesday 1st April 2014
quotequote all
snowwolf said:
I have the Roto fab on mine, easy to fit but you will have to reshape the plastic rad cover so you have a nice seal when bonnet is shut so all the cold air is sucked from down below from lower intake grill, when you look at your lower grill, on the right hand side you will see an air scoop, that's where it sucks the air from (don't drive through flooded roads) it comes with everything you need to do a very good install, when madmaxhsv Had the car connected to his laptop out on a run he was impressed at the low intake temps.
Did you import it from the US? If so do you remember what the total cost was like?

snowwolf

11,503 posts

206 months

Tuesday 1st April 2014
quotequote all
Z0m81e said:
Did you import it from the US? If so do you remember what the total cost was like?
Yes I imported it from USA think it was about £280 3 nearly 3 years ago but will check see if I have the receipt this evening, I went for the more expensive filter which is oil free

wiganhsv

Original Poster:

148 posts

153 months

Tuesday 1st April 2014
quotequote all
so can i ask snowwolf, why you went for that filter and not over the radiator, does that have any advantage over the other

snowwolf

11,503 posts

206 months

Tuesday 1st April 2014
quotequote all
wiganhsv said:
so can i ask snowwolf, why you went for that filter and not over the radiator, does that have any advantage over the other
I went for the Roto Fab for two reasons, one being the filter quality read better over the paper type and Essexvxr8 had already had one fitted and I liked the idea that the air is forced up from the air scoop in the lower bumper which is colder air so probably better.

Z0m81e

249 posts

173 months

Wednesday 2nd April 2014
quotequote all
I dropped them an email about shipping they said it was $65. I plugged that and the price into a duty calculator and it seemed to come out between about £290-300 with duties taken into account for the non-oil type filter so slightly cheaper for the oiled one. I don't know if they'd combine shipping if multiple people ordered or provide a discount for a group buy as I didn't enquire.

cheers
Paul