A4 Avant Rear Seat Belt
Author
Discussion

ysnnim

Original Poster:

235 posts

262 months

Tuesday 8th April 2014
quotequote all
Just bought an A4, and the buckle on the rear centre seat belt is below the 'button' on the seat belt webbing. so when the belt is pulled out to go round the passenger, the buckle does not move freely along the belt, and so cannot be used. Noticed this earlier this evening...

Any ideas? Does the button come undone at all?

Will look again when it's light, but just wondered if anyone had experienced this at all...

Cheers

DarkMatter

1,508 posts

262 months

Wednesday 9th April 2014
quotequote all
ysnnim said:
Just bought an A4, and the buckle on the rear centre seat belt is below the 'button' on the seat belt webbing. so when the belt is pulled out to go round the passenger, the buckle does not move freely along the belt, and so cannot be used. Noticed this earlier this evening...

Any ideas? Does the button come undone at all?

Will look again when it's light, but just wondered if anyone had experienced this at all...

Cheers
Yes, I've experienced that when (un-noticed by me) the MOT tester left the centre belt clipped in and I lowered the seat back which caused the inertia reel to wind in the belt - when I went to raise the seat back I had to overcome some resistance. Having raised the seat back I discovered that the buckle was the wrong side of the button.

I tried to force the buckle back over the button but this resulted in the button popping off. I didn't bother to replace the button (can you get a replacement?) and the belt still appears to function correctly.

Rich_W

12,548 posts

243 months

Wednesday 9th April 2014
quotequote all
IIRc it's a 2 piece thing that just presses together. with the belt webbing in between.

Careful use of a screwdriver or similar should split it apart. Perhaps CAREFULLY cut it in half with some side cutters.

As above, may as well chuck it afterwards. Won't affect MOT or anything.

ysnnim

Original Poster:

235 posts

262 months

Thursday 10th April 2014
quotequote all
Cheers chaps, pinged the 'button' apart with a knife... it broke, belt works perfectly now!