carbon dash

[Green3R]

Hi all, anybody happen to have a carbon dash insert they never got round to fitting that they would like to sell?

I think they were produced by Daddysumo? Have sent a PM direct.

Thanks

[mgbond]

If not then Jetstream do one

[Green3R]

ah yes, I need the full length one

Thanks

[StreetDragster]

Full length one?

Matt

[Green3R]

like this:



(pinched the image from an earlier PH thread, hope owner doesn't mind)

Thanks
Andy

[Adrian W]

good luck with fitting that

[GTO600]

Andy, PM sent.

[Blu3R]

Adrian W said:

good luck with fitting that

Why?

[StreetDragster]

Green3R said:

like this:



(pinched the image from an earlier PH thread, hope owner doesn't mind)

Thanks
Andy

Thanks, what thread did that picture come from?

Seems i have the 'full length' dash as well, didn't know it was a common feature and thought it was something a previous owner had done.

Matt

[Adrian W]

Blu3R said:

Adrian W said:

good luck with fitting that

Why?

It's a pig of a job

[Green3R]

fitting is simple.... getting the original off is the entertaining bit!

[Blu3R]

Adrian W said:

Blu3R said:

Adrian W said:

good luck with fitting that

Why?

It's a pig of a job

I see. I thought you were suggesting this type was worse than any others!

[andygtt]

Fitting it is easy peasy when you cut a double din size hole in it

[Rob_W]

I'm surprised you did make your own!

[sundance002]

I have a spare one for M400, ready to go if someone wants it? Gauge and light holes all cut out ready to go

[The devil]

Once you know where the fixings are it's not too bad to get out, I drilled mine and the new one is front fixed

[mgbond]

Green3R said:

ah yes, I need the full length one

Thanks

Jetstreams is full length but in two parts. So it's easy to get behind.

Edited by mgbond on Tuesday 13th May 20:49

[johns355]

I was only chatting to my son about doing this on mine, he replied "can you also get the silver trim around the speedo/gauges in carbon as well so it all matches?" Good point- anyone got these as well? John.

[sjc]

sundance002 said:

I have a spare one for M400, ready to go if someone wants it? Gauge and light holes all cut out ready to go

Craig did you get a PM from me?

[Green3R]

I've managed to get hold one one thanks to Kev (GTO600).

Thanks all