Rear lower Wishbone Adjuster - Thread Size?

[Boatbuoy]

Hello All,

Can anyone tell me with certainty what the thread size is of the rear lower wishbone adjuster bush is? To clarify, it's the thread shown in the image below:



It looks like a fairly fine thread to me. Image 'borrowed' from Powers Performance website, so thanks to them and I hope I haven't infringed any copy wright laws! :/

I'm desperately trying to get my car back together in time for Classic Le Mans so any urgent replies would be gratefully received.

Regards,
Olly

[phillpot]

Measuring the diameter of the shank would be a good start, my guess is 1/2" unf perhaps (same as wishbone pivot bolts etc.)?

[Adrian@]

Fact... 1/2 UNF nyloc.
Adrian@
There should be no washer used on the internal of the wishbone adjuster.

[Boatbuoy]

Thanks guys, much appreciated.

Just got to find someone/somewhere that'll sell me 2 x 1/2" UNF nyloc nuts by the weekend now!

[Adrian@]

PM your details and I will pop 2 in the post later.
Adrian@

[Boatbuoy]

You sir, are a true Gent, and it's people like you that make PH what it is. Last weekend - after 2 weekends lost to supplier issues - I was on the verge of throwing in the towel. Now I'm looking forward to it all again.

Thank you very much - YHM.

Best Regards,
Oliver