Gassing StationTVRCerbera
Water in exhaust manifold - pre strip down predictions?
PistonHeads » Gassing Station » TVR » Cerbera
Water in exhaust manifold - pre strip down predictions?
My ProfileMy PreferencesMy Mates
SearchMy Stuff
What's New3122472
Reply
OP Posts Only
OP Posts Only
Reply
OP Posts Only
Author
Discussion

Work-Shy-Wanabe

Original Poster:

1,547 posts

255 months

[report]
[news]
Wednesday 21st May 2014
quotequote all
The initial message was deleted from this topic on 17 October 2014 at 20:52

N7GTX

8,301 posts

172 months

[report]
[news]
Wednesday 21st May 2014
quotequote all
Go on then, I'll take a gamble. You forgot to torque down the rear head bolts on that side? confused

a1rak

556 posts

212 months

[report]
[news]
Wednesday 21st May 2014
quotequote all
Did you fit the correct washers/spacers under the cylinder head bolts. These are hardened washers specifically machined to size to fit in the machined surface on the cylinder head.


Reply
OP Posts Only
OP Posts Only
Reply
OP Posts Only

Gassing Station | Cerbera | Top of Page | What's New | My Stuff