Can you identify these please?

[djwilk]

Hi,
As some of you may know I am fitting my engine back into the vxr8.
Nearly everything is connected, but I don't remember where to connect the metal breather tube that is part of the off side rocker cover (the one with the oil cap). Also, I have got a three pin socket on top of the engine deck just behind rthe inlet manifold, but the plug that is supposed to be fit is too small and therefore unable to click in.

Anyone know anything please?

[djwilk]

Ok, I have found this:

http://m.ls1tech.com/forums/showthread.php?t=10923...

I can tick the box on the tube top of rocker cover.

The round connector is the Oil pressure sensor, but the only three pin connector that would be going into it is just too small...

[MyM8V8]

djwilk said:

Ok, I have found this:

http://m.ls1tech.com/forums/showthread.php?t=10923...

I can tick the box on the tube top of rocker cover.

The round connector is the Oil pressure sensor, but the only three pin connector that would be going into it is just too small...

Use the one off your old engine.

[ringram]

.. and if that also doesnt fit, then you are looking at the wrong thing!

[djwilk]

Thanks chaps,
I binned the old minor engine leftovers, but also learned from PWP that I got the corvette sensor. Also Camaro waterpump so getting that replaced whilst buying a new sensor.