Engine mounts

[ellis427]

What engine mounts is everyone using?

Unfortunately a long running issue became apparent in Le Mans, where by the engine obviously under load had been jumping, causing the top pulley to eat through the alloy head tank gradually! Had it welded in Le Mans but it has done it again.
Which is a major concern!

So is there only the standard mounts or are there better ones everyone uses?

Thanks for you time!

[Barreti]

I have these.
http://www.sc-power.co.uk/pages/sc-power-engine-mo...

about 3 or 4 years ago and all good so far.

[spend]

You can actually ignore that pulley if you don't have PAS & fit a shorter belt (@1140 rings a bell, but I've probably done it with different size pulleys). Probably a much better get-you-home than letting it chew the tank again in any case?

[p5000ko]

That's because you were showing off in Le Mans young man!! Great pit repair though, cant believe you just walked in!!

[Colin RedGriff]

I replaced my knackered ones last winter with the SC ones and they've been fine. My old ones where starting to crack so anything would have been better than what was there.

Here's a thread from the Chimaera forum which might help

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

[ellis427]

Mr clive its not my fault when people stop me in Arnage.The car revs to 3000 revs and the clutch slipped up,not my fault.
thanks for help i will fit the better mounts.