Painting Engine Parts

[Behold81]

I'm going of Hammerite as any type of paint because its quite frankly a pain in the butt.

What can I use as a good high temp paint for parts that will last the hot/cold process well?

Thanks

[Behold81]

Bump

[Cerberaherts]

I've used this stuff:
http://www.vhtpaint.com/products/engineenamel/

For many years, mainly their "wrinkle red" for Ferrari cam boxes. Here's a few pics of the process:

[Behold81]

Hmmmmm had not thought of a wrinkle finish.... I quite like that. Very stock looking.

Thanks.

[stevieturbo]

For most engine parts, normal aerosols will be just fine.

[Yanayaya]

Hammerite does well but I'd also recommend VHT paint as this can withstand a lot more especially with items close to turbo chargers etc etc. You can also by VHT lacquer specifically for engines if you want a shine on it

[alfienoakes]

I just did my pacemaker manifolds with Rust-Oleum heat resistant paint after having them blasted,
total crap, it bubbled up withing moments of starting the engine for the 1st time

[gsd2000]

ive used por 15 engine paint, but its still soft even after its cured so i am tempted to strip it and use 2 pack

[MadMaxHSV]

I've used 2 pack car paint on the block and other areas. Sticks without issue and has held up to heat and oils etc.

[jameshsv]

gsd2000 said:

ive used por 15 engine paint, but its still soft even after its cured so i am tempted to strip it and use 2 pack

When will your engine be finished m8.

[jameshsv]

gsd2000 said:

ive used por 15 engine paint, but its still soft even after its cured so i am tempted to strip it and use 2 pack

When will your engine be finished m8.

[gsd2000]

jameshsv said:

When will your engine be finished m8.

Dont know