996 xenon headlight levelling?
Discussion
Evening all,
Just had my car MOT'd today and noticed this evening that the near side light isn't self levelling. Anyone know if there is a sensor for each side of just one that sets both?
I know there's definitely a sensor mounted on the near side coffin arm but can't recall one on the other side. Just trying to work out where to start if anyone's had this issue that could shed some light (no pun intended) on this?
Just had my car MOT'd today and noticed this evening that the near side light isn't self levelling. Anyone know if there is a sensor for each side of just one that sets both?
I know there's definitely a sensor mounted on the near side coffin arm but can't recall one on the other side. Just trying to work out where to start if anyone's had this issue that could shed some light (no pun intended) on this?
Ok, so did a bit of research and found out the levelling motors are on the back of the headlights. There is a metal shield covering it held on with one torx screw, also clamping down an earth cable.
Surfaces were not clean to say the least and a rub over with some 80 grit sandpaper on the shield and the crimped end on the wire, it's cured it.

Surfaces were not clean to say the least and a rub over with some 80 grit sandpaper on the shield and the crimped end on the wire, it's cured it.

Gassing Station | 911/Carrera GT | Top of Page | What's New | My Stuff