Discussion
If it's a monaro (or vxr8 if its the same) I used these :-
http://www.ebay.co.uk/itm/400334367769
Needed to trim the tops of the "V" bit down a bit to allow it to clip behind the metal but is holding fine now.
EDIT: Basically the clip arrives as on the right, and need to file the red section down as on the left so it's the same thickness as the thin section. I used a needle file.

http://www.ebay.co.uk/itm/400334367769
Needed to trim the tops of the "V" bit down a bit to allow it to clip behind the metal but is holding fine now.
EDIT: Basically the clip arrives as on the right, and need to file the red section down as on the left so it's the same thickness as the thin section. I used a needle file.

Edited by FizzysCar on Tuesday 10th February 20:58
The ones in Fizzys post look a lot like I remember them.
After some research, I think this is the part number. 90459628
http://www.autovaux.co.uk/product/90459628-clip.as...
Sort of cross referenced it from a Pontiac GTO.
After some research, I think this is the part number. 90459628
http://www.autovaux.co.uk/product/90459628-clip.as...
Sort of cross referenced it from a Pontiac GTO.
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff


