E39 problem all phers
Discussion
Went to start my car today @ work and it seemed like the battery was flat. I checked the battery connections which were all good. Then i managed to get the car started. The fuel gauge, fuel miles left to empty read 0 (filled the tank yesterday) & the temperature gauge outside said -40
All the electrical s are still working fine except the above. Haven't plugged it in yet
any ideas?
All the electrical s are still working fine except the above. Haven't plugged it in yet
any ideas?
cars1993 said:
illmonkey said:
Battery.
Do you recon its dying and needs replacing hence why these issues are starting?A lot of places can do battery tests, pop to your nearest garage and ask.
But yes, probably not holding a good charge.
_Deano said:
How old is the battery/alternator and if you commute in the E39, how far do you travel each day?
Im not sure how old either of them are. I have every receipt of every bit of work done by bmw with the previous owner and a receipt for a battery is not in there. It looks like the original as its a BMW battery. When I first bought the car 1.5 months ago, it was flat by morning. Haven't had any trouble since then up until todayI do 50 miles per day
trickywoo said:
illmonkey said:
You want the battery to have 12V in it.
Technically you want at least 12.6v static. If its reading 12.0v its goosed.Symptoms like you describe are typical of a dicky battery on a 5.
DO check with the DVM both measuring on the battery terminals, /and/ on the clamps that attach to the terminals.
I had a fright in mine a month ago when it wouldn't start and wouldn't even be jumpstarted. With another car battery hooked-up I was measuring nonsense voltages.
Had a think and another go after work - realised I'd not been consistent in where exactly I was measuring. 14v across terminals but 3 volts across the clamps, wtf? Then found the +ve cable clamps was not as tight as it appeared (loose on the taper). Battery itself was fine, fully charged and has behaved perfectly since - it's only a year ol.
So - undo the 10mm T-clamp nuts and pull the clamps off, clean the all mating faces and try again, you might be surprised.
I had a fright in mine a month ago when it wouldn't start and wouldn't even be jumpstarted. With another car battery hooked-up I was measuring nonsense voltages.
Had a think and another go after work - realised I'd not been consistent in where exactly I was measuring. 14v across terminals but 3 volts across the clamps, wtf? Then found the +ve cable clamps was not as tight as it appeared (loose on the taper). Battery itself was fine, fully charged and has behaved perfectly since - it's only a year ol.
So - undo the 10mm T-clamp nuts and pull the clamps off, clean the all mating faces and try again, you might be surprised.
If you plan on keeping it, invest £40 in a C110 / C112 code reader. They're brilliant and pay for themselves many times over. They'll reset an iffy airbag light too.
Just on the offchance, check the under-bonnet positive battery jumper/connection. The one on the E46 comes lose very easily and creates a lot of spurious charging issues. However in this case it does sound quite ignition module related.
Good luck.
Just on the offchance, check the under-bonnet positive battery jumper/connection. The one on the E46 comes lose very easily and creates a lot of spurious charging issues. However in this case it does sound quite ignition module related.
Good luck.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff


