Car wont start - Ideas?
Car wont start - Ideas?
Author
Discussion

Riknos

Original Poster:

4,701 posts

235 months

Saturday 18th April 2015
quotequote all
Hi guys,

Have a 2001 Honda Accord that wont start. Been sat for a few weeks after previously being used every day. Would crank but wouldn't fire. Tested the battery and showing 12.5v so bought a new battery (520 cca 60ah) which didn't work, checked the plugs for spark and they were sparking fine but were wet, put new plugs in and tried starting the car with foot flat on the accelerator and cranked it for about 10 seconds but still no starting. Plugs smell of fuel so it's in the bores.

I'm guessing I've flooded it from trying to start with a half dead battery. but it's been left for a week between attempts (battery disconnected so alarm doesn't drain it) so even if flooded it should have dried?

Any ideas?

Tempted to sign up for rac/aa and then call them out next weekend - would they even let me do this or do I have to wait 2 weeks into the policy etc?

Thanks.

FreeLitres

6,128 posts

208 months

Saturday 18th April 2015
quotequote all
Probably not much use, but our old Golf tends to get a flat battery if we don't drive it for a few weeks. We bought a battery charger from Halfords which we just connect up for a few hours which brings the battery and car back to life.

73mark

774 posts

158 months

Saturday 18th April 2015
quotequote all
Try a friend and a set of jump leads.
Home > Engine Cranks But Won't Start
Engine Cranks But Won't Start

What’s causing the no-start? All engines require three things to start and run: spark, fuel, and compression. If any one of these isn’t there, you aren’t going anywhere.
Symptom:
Engine Cranks but won’t Start
Probable Causes:
Fuel Pump (P0230 to P0233)
PCM (P0600 to P0606)
Crank Sensor (P0355 to P0399)
Fuel Pressure (P0190 to P0194)
Chances are the Check Engine Light is not on, but you may find any of the following codes:

P0230 to P0233 Fuel Pump codes
P0600 to P0606 PCM related codes
P0335 to P0339 Crank Sensor codes
P0190 to P0194 Fuel Pressure Sensor codes
No spark due to a bad crank position sensor, a faulty ignition module or PCM, a problem in the ignition circuit (ignition switch, antitheft system, wiring, etc.), a faulty park/neutral safety switch, a bad ignition coil (only on engines with a single coil ignition), or wet plugs or plug wires (did it rain last night, did you just wash the engine?)

A less common cause is a worn starter that draws so many amps while cranking the engine that there’s not enough juice left to adequately power the ignition system and fuel injectors. Contributing factors might be a weak battery and/or loose or corroded battery cables.

No fuel because of a dead fuel pump, bad fuel pump relay, blown fuel pump fuse, plugged fuel filter or line, or failed PCM injector driver circuit or injector power supply relay. Or, the fuel tank might be empty (don’t believe what the gauge is telling you), or the fuel tank might contain contaminated fuel (water or too much alcohol) or the wrong type of fuel (whoops, somebody put in diesel instead of gasoline).

No compression because the timing belt or chain is broken, the timing belt or chain is loose and jumped out of time, or the overhead camshaft has snapped. A powerful scantool like AutoTap Express DIY can help isolate the root cause by capturing this information as in Figure 8.

Edited by 73mark on Saturday 18th April 18:46

Gooly

977 posts

179 months

Saturday 18th April 2015
quotequote all
Test crank sensor, cam sensor, fuel pump, fuel pump relay & fuse, pull plugs and check them, coilpacks / any associated leads and anything else related to ignition.

Won't be battery related if it's cranking over, it's either not getting fuel or not getting spark.

juliethotel

255 posts

180 months

Saturday 18th April 2015
quotequote all
Gooly said:

Won't be battery related if it's cranking over, it's either not getting fuel or not getting spark.
Or it's not getting the right amount of fuel/air.

My angle of attack would be, charge battery, take plugs out, crank engine to expel fuel, plugs back in, see if it starts.

Get some easy start in there if that fails.

sebhaque

6,536 posts

212 months

Saturday 18th April 2015
quotequote all
Silly question, is your intake blocked? Pop the cover off and have a look at the filter, is there definitely a clear passage for the engine to suck air in?

Riknos

Original Poster:

4,701 posts

235 months

Saturday 18th April 2015
quotequote all
Some good ideas here guys

No error codes at all

juliethotel said:
Gooly said:

Won't be battery related if it's cranking over, it's either not getting fuel or not getting spark.
Or it's not getting the right amount of fuel/air.

My angle of attack would be, charge battery, take plugs out, crank engine to expel fuel, plugs back in, see if it starts.

Get some easy start in there if that fails.
Definitely getting spark and fuel. I took the plugs out stuck them
On the block and turned the engine over and they all sparked. Definitely getting fuel as plugs are wet and smell of fuel - so not pump or filter.

Too much fuel maybe or not enough air?
Will take the plugs out and try cranking without.

What do I do with the easy start? Take off the air filter and spray in the intake manifold



PositronicRay

29,121 posts

214 months

Saturday 18th April 2015
quotequote all
An old trick, try heating plugs on a gas cooker and then have another go.

TheEnd

15,370 posts

219 months

Saturday 18th April 2015
quotequote all
If it's flooded, pull the fuel pump fuse, get another car as a booster and crank over and it'll end up clearing out whatever excess fuel is in there.

You might even get it almost trying to start as it leans out a bit.
Put the fuse back, ignition on and off twice or so for priming, and then try and start again.

Riknos

Original Poster:

4,701 posts

235 months

Saturday 18th April 2015
quotequote all
PositronicRay said:
An old trick, try heating plugs on a gas cooker and then have another go.
Brand new plugs fitted today and only tried to crank over for a few seconds - any point in doing this? Doesn't it just dry out the plugs?

Impasse

15,099 posts

272 months

Saturday 18th April 2015
quotequote all
Take the plugs out now and leave them out overnight to allow the bores to dry out. Re-fit and try again tomorrow morning.

Monkeylegend

29,597 posts

262 months

Saturday 18th April 2015
quotequote all
Had similar issues albeit with a Renault Scenic. One crank position sensor later and bingo.












It wouldn't start.





Oh yes it did, and has been ok ever since.

Who me ?

7,455 posts

243 months

Saturday 18th April 2015
quotequote all
PositronicRay said:
An old trick, try heating plugs on a gas cooker and then have another go.
If they are wet with fuel ,could be nasty. Safest done outside . leave plugs in open for fuel to evaporate and then warm with heat source.
You say it's getting fuel and spark, BUT is it getting spark at the right time. You've changed the plugs, so it's safe to think that it's not plug problems or a weak spark from dodgy plugs. With that set of info ,i'd be looking to check that timing is correct , proving that cam angle sensors are correct. Alternatively - are plug leads in correct positions. Shouldn't matter for modern ignition systems, but possibly. Other possibility is that starter is not turning fast enough ,which could be caused by dirty solenoid contacts, dropping more than 0.5v across them , or a sluggish starter motor.

Riknos

Original Poster:

4,701 posts

235 months

Saturday 18th April 2015
quotequote all
I'm [quote=Who me ?]
PositronicRay said:
An old trick, try heating plugs on a gas cooker and then have another go.
If they are wet with fuel ,could be nasty. Safest done outside . leave plugs in open for fuel to evaporate and then warm with heat source.
You say it's getting fuel and spark, BUT is it getting spark at the right time. You've changed the plugs, so it's safe to think that it's not plug problems or a weak spark from dodgy plugs. With that set of info ,i'd be looking to check that timing is correct , proving that cam angle sensors are correct. Alternatively - are plug leads in correct positions. Shouldn't matter for modern ignition systems, but possibly. Other possibility is that starter is not turning fast enough ,which could be caused by dirty solenoid contacts, dropping more than 0.5v across them , or a sluggish starter motor.
Good point. But car was working fine when used daily recently until I parked it up and stopped using it and it wouldn't start - then fitted new battery as old one was reading 12.5 so new one but then flooded it maybe so new plugs etc so surely can't be the timing?

jon@work

4 posts

239 months

Sunday 19th April 2015
quotequote all
I don't post often, so I hope this is worthwhile.....

I've also got a 2001 Accord and had a no-start incident similar to yours (fuel and spark looked OK).

Turned out to be corrosion inside the dizzy cap, only spotted by luck when turning the engine over in poor light with the bonnet open. Cue a plethora of sparks around the outside of the dizzy cap. £40 (ish) later on a genuine rotor arm and dizzy cap, problem solved.


edited for dodgy spelling

Edited by jon@work on Sunday 19th April 12:32


Edited by jon@work on Sunday 19th April 22:14

Leptons

5,493 posts

207 months

Sunday 19th April 2015
quotequote all
Staggered that anything that new would still use a Distributor TBH.



Edit- why are you trying to start it with your foot to the floor?

Edited by Leptons on Sunday 19th April 08:26

BOBTEE

1,034 posts

195 months

Sunday 19th April 2015
quotequote all
As above, try it with the fuel pump fuse pulled out. Might fire a few times, let it run if it will. Pop the fuse back in, try again. Repeat till it starts.

Also, as mentioned, worth checking the dizzy for corroded posts. If they're fuzzy and white, scrape them clean with a screwdriver...you may still need to do the above to clear the flooding smile

xRIEx

8,180 posts

179 months

Sunday 19th April 2015
quotequote all
Leptons said:
Staggered that anything that new would still use a Distributor TBH.
That surprised me too.

Leptons said:
Edit- why are you trying to start it with your foot to the floor?
I don't know if it works on all cars, but on some Jaguars pressing the pedal all the way down while starting cuts the fuel pump.