Stack installation on CanAM

[huzilulu]

Hey guys

For those who have fitted a Stack pod on a CanAm - how did you get the pod to sit flush along the top of the dash? The top is quite curved and the pod is leaving quite a gap on the outer side. Any advise is appreciated.

Thanks

[UltimaCH]

It is indeed a bit tricky and some fettling is needed. I will not know what the final look will be until everything is covered in leather.

[UltimaFAN]

Don ´t you have a threaded rod in the middle of your dash? On mine, when I tighten the nut, it pulls the dash against the Stack pod.

[huzilulu]

The inner side (lenght wise across dash top) is flush with the dash top, where as the outer side has a gap of almost 10-15mm... I'm worried if I tighten the nut too much it might crack the GRP?

[huzilulu]

To get the pod to fit I had to add epoxy paste and extend the pod on the outer side... almost done but it looks like this now:

[Steve_D]

I have a Stack dash in my GTR and found I needed to grow a peek on the front of the pod to both shade it from sunlight and stop the dash from reflecting off the windscreen at night.

Steve

[Storer]

If you are not trimming it you could coat the outside with gel coat, sand, cut and polish it to look right.

Paul