Stone guards - worth fitting?
Discussion
rossyl said:
Hi All,
Just wondered if stone guards were worth fitting to a 2006 (56) Vantage?
If they view is yes - How Hard are the to Fit?
Also, is the film just in front of the rear wheel still required with these in place?
Thanks,
R
I'm having some fitted this afternoon. They cover the whole of the bottom skirts....I had these resprayed a couple of weeks ago and there are already some small chips so I think it might be worthwhile.Just wondered if stone guards were worth fitting to a 2006 (56) Vantage?
If they view is yes - How Hard are the to Fit?
Also, is the film just in front of the rear wheel still required with these in place?
Thanks,
R
hanny1973 said:
I'm having some fitted this afternoon. They cover the whole of the bottom skirts....I had these resprayed a couple of weeks ago and there are already some small chips so I think it might be worthwhile.
Is yours pre 2007 (when I think they had pilot holes for the stone guards?)If so, how do they fit them?
I made and fitted my stone chip protectors a couple of weeks ago due to having the V12 side sills fitted on my V8 Vantage.
I made some templates and bought some 3mVentureshield to cut out (Or you can purchase straight from AM if you want) there are lots of different grades of protective film (Search this website and you will find out)
In a nutshell:
1) Clean the areas where they need fitting.
2) Spray the car and stone chip protectors with a diluted washing up liquid mix, this helps them slide into position (NOTE: Avoid getting finger prints on the sticky side of the stone chip protectors)
3) Peel back and slide into position
4) Squeeze out bubbles and excess washing up liquid using a squeegee (as used for car wrapping)
5) Leave to dry and clean
6) Re-apply any paint surface treatment around the areas of the stone chip protectors.
I did mine and they look really good and saved a few quid in the process.
I made some templates and bought some 3mVentureshield to cut out (Or you can purchase straight from AM if you want) there are lots of different grades of protective film (Search this website and you will find out)
In a nutshell:
1) Clean the areas where they need fitting.
2) Spray the car and stone chip protectors with a diluted washing up liquid mix, this helps them slide into position (NOTE: Avoid getting finger prints on the sticky side of the stone chip protectors)
3) Peel back and slide into position
4) Squeeze out bubbles and excess washing up liquid using a squeegee (as used for car wrapping)
5) Leave to dry and clean
6) Re-apply any paint surface treatment around the areas of the stone chip protectors.
I did mine and they look really good and saved a few quid in the process.
Me too. Just had 'stone guards' fitted to ours and also have film on the sills. I live at the end of a pretty filthy road that means even when the car is spotless when it leaves the house by the time it reaches the main road it is filthy again. The mud flaps will help with that. I think they look pretty good as well.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


