Logitech Harmony Remote suddenly stopped for one device?

[Andehh]

I set up a logtech Harmony remote earlier to work with my Pansonic TV, Sony Receiver and sky box.

All worked fine, with me able to switch between the apps on the TV (Netflix) and back to Sky TV.


Suddenly came to use it this evening and my Pansonic TV is no longer responding to it. All other devices switch & work fine. The TV responds fine to it's default remote, but despite removing & re-adding the TV and manually 'learning' the commands off the default remote I can't get it to work again. I have also tried re-adding extra commands to the Harmony to replicate pushing each button a few times to see if it's slightly off signal.

I have also tried resetting the remote & re-syncing it.

The only change has been adding in a central speaker below the TV, but this is about 50cm from the IR receiver on the TV.

Anyone ever experience anything like this before?

[Andehh]

For some reason it is trying to control my TV through the Logitech hub. This is in the cupboard under the stairs with my Sky box & Receiver.

Fiddling deeper into the settings I managed to force the netflix button to work directly from the remote -> to the TV, instead of the remote -> hub -> TV (!?). Never asked for this change, but at least it gives me an idea of where to go next.

Just need to try and force *all* TV buttons to go from remote -> TV and not remote -> hub -> TV which it seems to be trying now.

edit: and found instructions here;

https://support.myharmony.com/en-gb/control-device...

Edited by Andehh on Saturday 7th November 18:28

Edited by Andehh on Saturday 7th November 19:22