Wheel arch liner removal

[Ekaplan1020]

This last weekend I attempted to remove the wheel arch liner on my 2005 DB9 to change out the door struts and the side marker light. I jacked up the car and removed the wheel. I unscrewed the numerous bolts, but could not figure out how to remove the liner as I didn't want to undo the entire underbody. I checked the workshop manual, but did not see anything that helped and was hoping someone on here could provide some guidance (and perhaps photos) of how to remove the liner to access the struts. Do I need to take the entire liner out to get to the struts? Also, I purchased the 10mm flex head racketing wrench as discussed in other threads to remove the side marker lights, but unfortunately it doesn't appear to be the correct size. Would it be easier to remove the air box to gain access or is that an even bigger struggle?

Any help is appreciated.

Thanks,
Ethan

[Sump]

Gotta room ally undertray and then there are some 10mm bolts on the front of the wheel arch liner that follows the curve of the bumper around. Real PITA if on jacks.

[mrpseudonym]

Done the door struts. Just remove all of the wheel arch liner bolts and push liner to the side, you don't need to remove it completely.

[Ekaplan1020]

mrpseudonym said:

Done the door struts. Just remove all of the wheel arch liner bolts and push liner to the side, you don't need to remove it completely.

Did you remove the wheel as well?

[mrpseudonym]

Yes