BMW 645CI. No Heat.
BMW 645CI. No Heat.
Author
Discussion

cindydog3

Original Poster:

158 posts

167 months

Friday 19th February 2016
quotequote all
The only heat available at present are the heated seats! At best after a run air temp from vents is tepid. No loss of coolant apparent at expansion tank which was replaced 4k miles ago. Valley waterpipe replaced 30k miles ago.

Might this be electrical eg heater switching or whatever?

Don't like a lot of heat in the car so have only become aware of this gradually over the past few weeks.

All suggestions welcome.

minimatan

17,967 posts

232 months

Saturday 20th February 2016
quotequote all
It's not something obvious such as the settings set to cool on the idrive climate screen?

cindydog3

Original Poster:

158 posts

167 months

Saturday 20th February 2016
quotequote all
minimatan said:
It's not something obvious such as the settings set to cool on the idrive climate screen?
Thanks for that,had already looked at settings on idrive and seem ok!

Collectingbrass

3,020 posts

226 months

Monday 22nd February 2016
quotequote all
Do you get air flow into the cabin without heat, or no air at all? If the later it could be the cabin / pollen filter is blocked, if the former it might be worth trying to bleed the coolant circuit in case there is an air bubble preventing hot water entering the heater matrix.

rassi

2,520 posts

282 months

Monday 22nd February 2016
quotequote all
Not the same problem with the Final Resistor Unit ("hedgehog") as on the E39, which would also stop heat/make the HVAC very erratic?

cindydog3

Original Poster:

158 posts

167 months

Monday 22nd February 2016
quotequote all
Thanks all so far. No problem with airflow except cold! Have warmed up engine and felt all hoses that are easily accessible, which are warm. Tried bleeding at expansion tank without success so will pursue other options. Where is heater matrix located?

Collectingbrass

3,020 posts

226 months

Monday 22nd February 2016
quotequote all
Did you have the heater on full demand when you bled it?

Have a browse of these:

http://www.bmwforums.info/3-series-guides/2181-how...

http://www.bimmerfest.com/forums/archive/index.php...

cindydog3

Original Poster:

158 posts

167 months

Monday 22nd February 2016
quotequote all
Collectingbrass said:
Did you have the heater on full demand when you bled it?

Have a browse of these:

http://www.bmwforums.info/3-series-guides/2181-how...

http://www.bimmerfest.com/forums/archive/index.php...
Thanks C/Brass/JS. Enough to be going on with on these 2 forums. Will let you know how I get on.