E36 318iS Radiator
E36 318iS Radiator
Author
Discussion

Paul S4

Original Poster:

1,315 posts

241 months

Saturday 12th March 2016
quotequote all



I have been getting my 318iS ready for the summer; put new plugs in ( realised that the previous ones had done about 23,000 !) and that is assuming they were new when I bought the car 2013 ! The plugs were really tight and just as well the handy blue plastic removal tool was still in place to aid removal of the leads/shrouds.
Anyway, took off the front 'plastic radiator cover thing ' and was quite surprised at the radiator mounting : I assume it is mounted so that it can flex a bit ? It must be on rubberised mountings ? I nipped up all the bolts I could see ( there was a bit of that needed but not much. ) It still flexes a bit.

As some of you will have noticed by now, the power steering cooler is not fixed properly. The N/S bolt has rusted and it was not fixed on that side at all- hence my make-shift cable tie fix plus the others to retain the self tapper bits as well. The cooler itself is a bit rusty ( it must get all the crap being right at the front !) but after cleaning it up and testing it with a brisk run out there are no leaks. Took the car into the local BMW Main dealer in Durham (who are very good I must say ) and the new plugs seem to have made a difference. I have ordered a set of the special rubberised mounts for the cooler, hoping to get them fitted next week ; the old ones are going to be a b******d to remove but Plus Gas is my friend here !
Whilst I was at the BMW dealer I enquired about a new steering oil cooler.....only about £150 (!!!) all that for what is basically a bit of coiled pipework !

I did notice from the computer drawings that the cooler is attached to a block just under the N/S bonnet catch so if I ever need to replace the cooler I may be able to modify it to; either a) adapt to an oil cooler of some sort, or) more likely block it off !

Not sure if my car really needs a steering oil cooler....It does get quite warm to the touch, but then again I have done a few track days at Croft so it may have served a purpose then !

I am preparing the car before driving down to Monaco in May for the Historic F1 Weekend ; did it 2 years ago in the same car and it was a great trip, if a little tiring as the car has a Milltek cat back system/remap so it gets a bit noisey on the Autoroutes ! Sounded wonderful when climbing up to the Col de Turini on the Monte route though smile


BGarside

1,568 posts

168 months

Saturday 12th March 2016
quotequote all
My coupe has the same mountings. Just two plastic clips
at the top. It looks to be easy to replace the rad anyway!

My PAS cooler is underneath the engine next to the steering rack though so more vulnerable to rust and damage. £150 you say.....