DB9 Brake pad wear sensors

[Horts]

Just about to change my pads front and rear and the wear sensors have come on, so now need to change the sensors as part of the pad change.

Can't see where the sensor runs too, one assumes I have to remove the wheel arch liners back and front to gain access?

Thanks

Horts

[8Tech]

You should replace the pad sensors as a matter of course anyway. I believe you can get to the connector without removal of the arch liner although you may need to loosen a couple of fixings to get a decent grip on the connector.

[old phart]

Documented when I did my front brakes.

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

[Horts]

Thanks guys much appreciated for the help!

Horts

[westhumbler]

Does anyone know if the brake pad wear sensors are Aston specific or a Jaguar part? If so, does anyone know the Jaguar part numbers be for the front and rear?

Thanks in advance

[JonnyCJ]

https://www.pistonheads.com/gassing/topic.asp?h=0&...

[westhumbler]

Thanks Jonny

I was keen to buy the same part rather than something from ebay.

Does anyone know if there is an equivalent Jaguar part?

[JonnyCJ]

westhumbler said:

Thanks Jonny

I was keen to buy the same part rather than something from ebay.

Does anyone know if there is an equivalent Jaguar part?

It's two wires that complete a circuit. When they wear through the circuit breaks and triggers the light. The eBay ones are as good as OE.

[westhumbler]

Thanks