2007 E91 320i VANOS issues...
Discussion
I have a 57 plate 320i, thats decided to throw a hissy fit at the 86000 mile mark and thrown an orange engine management light...
Symptoms are a low/unstable idle, and some vibration, but no obvious VANOS rattle.
Have got it diagnosed by a local garage (in a bid to avoid driving it too far whilst in it's current state) who have politely told me it's outside of their area of expertise...
Fault codes are P1050 (Variable Valve Timing - Control Circuit (Bank 1)) and P1062 (Variable Valve Timing - Limp Home Request Full Stroke Position Not Reached) to be precise.
Does anyone have an idea of how much it would cost me to get this sorted, as having searched around the forums the VANOS horror stories all appear to cost >£1000 to fix, which won't tie in particularly nicely with my current financial status (23 year old student....)
Thanks for your help
Symptoms are a low/unstable idle, and some vibration, but no obvious VANOS rattle.
Have got it diagnosed by a local garage (in a bid to avoid driving it too far whilst in it's current state) who have politely told me it's outside of their area of expertise...
Fault codes are P1050 (Variable Valve Timing - Control Circuit (Bank 1)) and P1062 (Variable Valve Timing - Limp Home Request Full Stroke Position Not Reached) to be precise.
Does anyone have an idea of how much it would cost me to get this sorted, as having searched around the forums the VANOS horror stories all appear to cost >£1000 to fix, which won't tie in particularly nicely with my current financial status (23 year old student....)
Thanks for your help
I had exactly the same codes on my 120i a few weeks ago, the BMW codes are 2A67 - VVT Activation and 2A6B - Power supply limit VVT emergency, the P codes are more generic.
I was able to get the codes cleared, which took the car out of limp home mode, but prevented the BMW specialist from diagnosing the fault. I was told that the valetronic motor is £205 + VAT + 2 hours labour, but equallly that it could be the sensor, so I'm best to take it back when the fault code is displayed again. It has been running fine since though.
I was able to get the codes cleared, which took the car out of limp home mode, but prevented the BMW specialist from diagnosing the fault. I was told that the valetronic motor is £205 + VAT + 2 hours labour, but equallly that it could be the sensor, so I'm best to take it back when the fault code is displayed again. It has been running fine since though.
The eccentric shaft motor can get carbon dust interfering with it's operation, sometimes light tapping on the motor case disturbs it and can allow it to work for a period. Also poor oil condition is quite an issue, and things can get tight/sticky with tarnishing or plain old gloop. Only my2p.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


