Fog Light Problems
Discussion
Hi all ! After a Rear light conversion (Mainland Europe) the fog light did Not work anymore. The Fog light switch was illuminated, but No light at the Rear end... Yesterday i Fund out, that one of the contacts under the rubber covers was lose. When i squeezed the rubber it worked,, When i let go, it won't work. So i opened the rubber, with a Cutter. As i tried to reattach the positive cable back to it' s Former Place iI caused a Short circuit. After that the fog lamp did Not work anymore. I checked the fuse, it was ok. But the Illumination of the fog light switch was off now and I was unable to Switch it on again. Did I killed the Switch? Or the control box? Any ideas and hints? Many thanks in Advance.
Chefs
Seppele
Chefs
Seppele
Standard advice really but I would start by taking out the fog light switch and test that it's getting 12V on the hot side when the headlights are on (measured against a suitable ground, eg a long bit of wire from the battery -ve or chassis). If there's no power there then you need to refer to the wiring diagram and follow it back to see where it goes. If there is 12V there then your switch is knackered.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff



