Well, I found a 2002 Tii in a barn...
Well, I found a 2002 Tii in a barn...
Author
Discussion

dr Dunkel

Original Poster:

21 posts

245 months

Thursday 14th April 2016
quotequote all
It'd been sitting there for about 20 years. It's a dry place so it's not a rust bucket. The numbers checked out and I bought it for the equivalent of £1k and I'm thinking of getting it back in shape.

Can you help me with sources of parts? I'm in contact with BMW Germany and they have a lot of parts, but I'd like alternatives. Any suggestions?

jayemm89

4,475 posts

161 months

Thursday 14th April 2016
quotequote all
There will no doubt be breakers, but I restored a Porsche a while ago and often found that Porsche themselves were the cheapest and quickest supplier of many parts. A Porsche club membership saved 10% off parts too, BMW might be similar

dr Dunkel

Original Poster:

21 posts

245 months

Thursday 14th April 2016
quotequote all


Thanks for the tip, but I need other vendors to compare prices.

geeks

11,901 posts

170 months

Thursday 14th April 2016
quotequote all
For a car like that I would be going down the genuine route wherever possible

dr Dunkel

Original Poster:

21 posts

245 months

Thursday 14th April 2016
quotequote all
geeks said:
For a car like that I would be going down the genuine route wherever possible
I got the Inka car - a regular 1975 2002 - in the deal. Yes, that's just what I'm thinking. I just need to know where to source parts as cheap as possible.

iSore

4,011 posts

175 months

Thursday 14th April 2016
quotequote all
2002 and 'cheap' are rarely bedfellows. The cost of restoring these cars is high, due to the eye watering cost of parts and often non availability. Bonnets and boots are NLA and good luck finding good used ones. Doors are about £450 each. Front wings are about £500 each although pattern ones can be found. Brake parts such as master cylinders and servos - all of will be knackered on yours - are NLA. However you can use new Lockheed MGB servos (200 quid a pair) and if the master cylinder bore cleans up, you can get a seal kit.

Radiators are BMW only and £500. Yours may be fit to be recored, it may not. Tii's have bigger brakes and unique front struts as well as box section rear arms that rot out. As it's a square tail light car it will (or should) have an E12 type engine with E12 cast into the side of the head. Any new parts for the Kugelfischer injection are £££££££ if you can find them. The trouble with the '02 is that the mainstream parts places discontinued service parts long ago so you're at the mercy of specialists who know how to charge, and BMW who REALLY know how to charge! A clutch centre plate is nearly £250 with VAT.


Before you even take a spanner to it, go all over the car and make a list of everything it needs (a lot). Then spend half a day pricing it all up.

E30Addict

825 posts

203 months

Thursday 14th April 2016
quotequote all
dr Dunkel said:
Can you help me with sources of parts? I'm in contact with BMW Germany and they have a lot of parts, but I'd like alternatives. Any suggestions?
BMW will have stock (more than you might imagine) but eye-watering prices. Check Walloth & Nesch (Germany) and Jaymic (UK) as a starting point.

Great find! thumbup

4rephill

5,171 posts

209 months

Thursday 14th April 2016
quotequote all
If My old E12 5 series was anything to go by, check carefully that there is no corrosion underneath the original factory under-seal.

With the surface of the under-seal cleaned of, it all looked pristine, with all the painted sealant looking as beautiful as when it left the factory back in 1980.

On peeling the under-seal away though, it was as rotten as an old pear everywhere! frown

The factory sealant on the E12 was a thick, barely flexible substance that felt almost like lino when you bent it, and I would suspect that the 2002 would probably be the same. If it is, it could be hiding a nightmare underneath! (I've got My fingers crossed for you that I'm wrong though! smile )



ethomas

326 posts

261 months

Thursday 14th April 2016
quotequote all
The best place I have found for BMW parts is Leebmann24.de in Germany. The prices are great, and they have linked their stock to a realoem style parts catalogue, so you can easily drill down and find all the parts you need for a particular job. For example, the master brake cylinder for the 2002ti is here:
http://www.leebmann24.de/bmw-ersatzteile/#!lang=en...

The complete part is still available and about 240 euros, or you can get a repair kit for 110. If you register an account and get in touch with them, tell them you are a member of Pistonheads (or any other forum) and they will activate a discount code that gives between 5 and 20 percent off everything. Postage is max 20 euros, and takes 2-3 days.

You want to start off with ERSATZTEILSUCHE, then pick your car (Classic -> 1502-2002), and then click the little British flag to make everything understandable.

The only problem is that it makes it so easy to find and buy parts, that you end up spending way more than you thought you would smile

RichardM5

1,861 posts

167 months

Thursday 14th April 2016
quotequote all
Always check the price on the BMW Classic web site,

As they have the price on the web site you can easily compare before you buy elsewhere, it also gives you a good idea what still available and what's not. They are almost always cheaper than dealer prices depending on what discount you can get at the dealer and the € exchange rate. If you order parts worth more than €100, shipping is free.

iSore

4,011 posts

175 months

Friday 15th April 2016
quotequote all
The other thing is - do a colour change! Pastelblue was a grim colour then, and is now. Inca orange or Golf yellow are great colours for adding value, as is Taiga green. A bright seventies colour helps what was never the prettiest of seventies cars. Given that a really good Tii is knocking on the door of 20 grand, if you can do the work yourself and the body's not fked, you could be onto a winner.