AIM MXL2 - MBE communication

[repsna]

have problems to get the wheel speed (speedo) out of the MBE 9A4 onto the AIM MXL2 screen with can+ and can-.
Do You have any experience? What do I need to configure?
Thanks Hanns Per

[sfaulds]

This is a bit vague - what is the problem exactly? Can you not see the channel at all in the MXL? Can you see it, but not display it? Is it displaying speed but not correctly?

Starting at the beginning, how have you got wheel speed into the ECU in the first place?

[repsna]

thks for your reply
I can see the speed in Easymap but not on the MXL2 screen. Easy map gets it from the wheel speed sensor.
What else is important to know to tackle this issue?
Thks again Hanns Per

[fergus]

Can you see *any* data via the CANbus from the Easimap ECU? Be aware that the AIM software supports a lot of CAN protocols. It may be that you need to select an alternative protocol?

If you're still stuck, speak with Easimap to see what protocol they're using, then speak to your nation AIM dealer, who should be able to help ,or if not, they will push the question back to Italy for you.

PS doing everything via CAN is the way forward. It *massively* clears up all the dash wiring. It just takes a bit of setting up.

http://www.aim-sportline.com/download/ecu/racing/M...
http://www.sbdev.co.uk/Info_sheets/MBE/MBE%20CAN%2...

Edited by fergus on Monday 18th April 10:36