Eccentric Shaft Position Sensor
Discussion
Hi, after I've finally got a Carly adaptor and run a diagnostic check it looks like my eccentric position sensor is fubbard. I've armed myself with very helpful diy guides and the Bentley manual and decided to diy it.
I've ordered the new sensor and associated gaskets etc. But I'm struggling to get a complete list of tools that I'll need before I start as I'll be near no shops etc.
I've got electrical contact cleaner, torx sockets etc. But I've read I may need reverse or female torx sockets and I'm going to order a torque wrench.
Anything else I've missed?
Also it's the first time I've done anything with gaskets so will I need any paste etc.?
Cheers guys.
I've ordered the new sensor and associated gaskets etc. But I'm struggling to get a complete list of tools that I'll need before I start as I'll be near no shops etc.
I've got electrical contact cleaner, torx sockets etc. But I've read I may need reverse or female torx sockets and I'm going to order a torque wrench.
Anything else I've missed?
Also it's the first time I've done anything with gaskets so will I need any paste etc.?
Cheers guys.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


