Door not locking on Chimaera?
Door not locking on Chimaera?
Author
Discussion

Corin Denton

Original Poster:

8,762 posts

297 months

Sunday 6th March 2005
quotequote all
Afternoon all, on my 1998 Chimaera with the Meta alarm system the near side door is not locking when I set the alarm??

Any ideas?

2 Smokin Barrels

32,006 posts

264 months

Sunday 6th March 2005
quotequote all
I've had this before on a few occasions. I think each time it was a different problem. (Sorry!)

I think, however, that on one occasion everything had gotten out of sinc with everything else. I think the solution that time was to disconnect the battery, leave it for a while,reconnect, and Roberts's yer father's brother. (It's a cheap one to try anyway)

andy4200

5,125 posts

302 months

Sunday 6th March 2005
quotequote all
Do you have the door sensors at the bottom and the magnet on the sill.

On the cerb when this happens we usually find that some of the wires to the sensor have corroded. Replace them with bullet connectors or something like that.

edward1

839 posts

295 months

Monday 7th March 2005
quotequote all
Check the solenoid hasn't stuck, I had this problem on mine after leaving it unused in the garage for a couple of cold winter weeks. The solenoid was sticking. Some WD40 followed by some light grease and it has been fine since.

Ribol

11,993 posts

287 months

Monday 7th March 2005
quotequote all
Sorry to state the obvious but as it is only one door which has the problem the alarm side of things can be ruled out.
Probably a door solenoid problem or bad connection. Have you checked the pin switch?
If it turns out to be the solenoid Maplin do them dirt cheap

Corin Denton

Original Poster:

8,762 posts

297 months

Tuesday 8th March 2005
quotequote all
Thanks everyone - will do some investigations!