E92 330i Misfire, Cylinder 2
E92 330i Misfire, Cylinder 2
Author
Discussion

Sam.

Original Poster:

316 posts

152 months

Wednesday 10th August 2016
quotequote all
Still getting issues with misfire cylinder 2.

Have replaced 6 coils, 6 plugs and 6 injectors.

Have replaced the lambda sensors and had the software updates to the newest version yet ill still get it misfire under load at 3k RPM.

Any ideas? Im going to be checking the wiring tonight for the ignition coil


E-bmw

13,656 posts

183 months

Wednesday 10th August 2016
quotequote all
Have you had a compression test done?

Have you had the engine wiring loom checked?

Sam.

Original Poster:

316 posts

152 months

Wednesday 10th August 2016
quotequote all
Compressor check shows up fine. Had a leak down test done showing 3% leak between cylinders. Nothing to be worried about

Im intending to check the wiring over for the injector harness tonight.

nitrodave

1,262 posts

169 months

Wednesday 10th August 2016
quotequote all
is the engine light coming on and have you had it red for fault codes? It may not always show up on a basic reader though.

Considering what you've changed, my guess now would now be fuel pumps.

Sam.

Original Poster:

316 posts

152 months

Wednesday 10th August 2016
quotequote all
It will drive fine, Will then misfire under load. Have checked the code with multiple diagnostic systems and all comes up with cylinder 2 misfire. I feel that it would cause it over multiple cylinders not just cylinder 2 over and over if the fuel pump was dead.

helix402

7,913 posts

213 months

Wednesday 10th August 2016
quotequote all
Were the decoupling elements changed with the injectors? Were the injectors coded to the DME?

Sam.

Original Poster:

316 posts

152 months

Wednesday 10th August 2016
quotequote all
New decoupling elements fitted, Injectors were coded into the DME.


tgr

1,256 posts

202 months

Wednesday 10th August 2016
quotequote all
What model year N52?

Sam.

Original Poster:

316 posts

152 months

Wednesday 10th August 2016
quotequote all
N53 Direct Injection Lean Burn Engine


Mr Tidy

31,913 posts

158 months

Wednesday 10th August 2016
quotequote all
Just a thought, but when I got a misfire on my 325ti (M54 engine) and the EML lit up my local BMW specialist diagnosed it as a H(ydraulic) V(alve) A(ctuator) issue (so a dodgy hydraulic tappet in old-speak)! I had done a few short stop/start trips in the days leading up to it, followed by a good long run of 200 miles during which it ran fine and the EML went out.

Hope you get it sorted!


helix402

7,913 posts

213 months

Thursday 11th August 2016
quotequote all
One more idea, I have seen one BMW where there was still a misfire despite a new coil, the output stage to one coil in the DME had failed.

Sam.

Original Poster:

316 posts

152 months

Thursday 11th August 2016
quotequote all
helix402 said:
One more idea, I have seen one BMW where there was still a misfire despite a new coil, the output stage to one coil in the DME had failed.
I had seen that. Weirdly enough the last 2 days since i posted this, the car has been behaving fine. Since i put the new O2 sensor in that looked as if it had had its day.

Im getting no hesitation, no misfire, pulls strong, mpg is brilliant.

I think i may of got to the bottom of this.

bmwmike

8,803 posts

139 months

Thursday 11th August 2016
quotequote all
Fingers crossed! Just had a new set of injectors myself. Wonder how long they last these days? I did consider running with the engine cover off to try and help airflow as they get very hot. Noting the n55 has specific coolant passages to keep the injectors cool (they are a different type of injector to n53 anyway).