Thread Size

[LongBaz]

Can anyone tell me the thread size of the temp sender housing in the actual inlet manifold. I need to buy reducer to fit my Cerbera sender.
Thanks
Barrie

Edited by LongBaz on Friday 2nd September 10:44

[Sardonicus]

Barry look here this conflicts with what I assumed down the page a bit http://www.pistonheads.com/gassing/topic.asp?t=781...

[Steve_D]

Just been doing some measurements.
So the lower point on the inlet consists of three parts.

Screwed into the inlet is a steel adaptor with a 3/4-16 UNF male thread. It then has a 1/8NPT female thread in the other end.

Next is the long brass section with 1/8NPT male and at the other end 5/8-18UNF female.

The sender is 5/8-18 UNF.

Hope that helps.

What thread do you have on your capillary sender?

Steve

[LongBaz]

Thanks Steve
The capillary is 5/8 UNF.
Barrie

[Steve_D]

I did notice today that Racetech do a much shorter, one piece, adaptor which may be of use.

Steve

[LongBaz]

Thanks Steve
I'll call them tomorrow
Barrie