350I Clutch Slave , repair kit or replacement,

[gas mart 1]

The clutch slave cylinder on our 350i is leaking fluid through the seals, I had a look through the Wedge part numbers on here , but found nothing listed. Is it an SD1 part available from Rimmer bros.?
Cheers
Martin

[KKson]

Personally unless there's a wear "shoulder" on the inside of the bore I'd put a seal kit in. Only a few quid off flea.

http://www.ebay.co.uk/itm/TVR-S-2-9-Tasmin-Wedge-C...

New slave cylinders are available from Rimmers but make sure it's the correct outlet pipe thread as there are two. Neil at ML Performance also stocks new ones with the correct thread.

http://www.mlperformanceparts.co.uk/product/clutch...

[gas mart 1]

Many thanks. not removed it yet , will strip it down and check for wear.

[wild rover]

Land Rover 90 clutch master fits, you need to use the original arm and possibly the pipe connection.